Explanation:
This happens because there is a buoyant force acting on the ball.
Answer:
B. Technician B only
Explanation:
An oscilloscope can be used to check the output signal of an optical sensor. The oscilloscope has the functioning of viewing the results in the form of waveform and its time scale settings can be altered to meet the requirements of the results.
A voltmeter cannot be <u>directly</u> used to monitor the output signal of an optical sensor. But a <u>digital multi-meter</u> can be used to check an optical sensor if the digital multi-meter is set on AC - Volt reading mode.
If you have no way to accurately measure all of the object's bumps and dimples, then the only way to measure its volume is by means of fluid displacement.
-- Put some water into a graduated (marked) container, read the amount of water, drop the object into the container, and read the new volume in the container. The volume of the object is the difference between the two readings.
-- Alternatively, stand an unmarked container in a large pan, and fill it to the brim. Slowly slowly lower the object into the unmarked container, while the pan catches the water that overflows from it. When the object is completely down in the container, carefully remove the container from the pan, and measure the volume of the water in the pan. It's equal to the volume of the object.
Public sphere is a concept created in the 18th century and further developed by Jürgen Habermas, who stated that the public sphere was characterized by it's critical nature in contraposition to the representative nature of the feudal system
