Answer:
Therefore the the highest frequency is 620Hz and lowest frequency is 580Hz
Explanation:
Given data
Source Frequency fs=600Hz
Length r=1.0m
RPM=100 rpm
The speed of the generator is calculated as:
Substitute the given values
For approaching generator the frequency is calculated as:
On the other hand,for the receding generator,Doppler's effect is expressed as:
Therefore the the highest frequency is 620Hz and lowest frequency is 580Hz
Answer: Newton, the unit of force, is defined based on Newton's Second Law (F=ma), as the force required to give a mass of one kilogram an acceleration of 1 meter/second2. Thus, it is derived from these other units.
Explanation:
First,
where is density, is mass, and is volume. We can compute the volume of the roll:
When the roll is unfurled, the aluminum will be a rectangular box (a very thin one), so its volume will be the product of the given area and its thickness . Note that we're assuming the given area is not the actual total surface area of the aluminum box, but just the area of the largest face (i.e. the area of one side of the unrolled sheet of aluminum).
So we have
where is the given area, so
If we're taking significant digits into account, the volume we found would have been , in turn making the thickness .
A. 10 rations = 1 deca-ration.
b. 2000 mockingbirds = 2 x 10³ = 2 kilo-mockingbirds.
c. 10⁻⁵ phones = 1 micro-phones.
d. 10⁻⁹ goats = 1 nano-goats.
e. 1018 miners = 1.018 x 10³ = 1.018 kilo-miners.