When we say toolmark, this describes as the mark that is produced by a particular tool. This is typically used in forensic science for identification. Based on the examples above, the one that is not the proper use of casting of a toolmark is option B. Hope this helps.
Answer:
thanks for the points liar
Explanation:
Answer:
The minimum frequency of the coil is 7.1 Hz
Explanation:
Given;
number of turns, N = 200 turns
cross sectional area, A = 300 cm² = 300 x 10⁻⁴ m²
magnitude of magnetic field strength, B = 30 x 10⁻³ T
maximum value of the induced emf, E = 8 V
Maximum induced emf is given as;
E = NBAω
where
ω is angular velocity (ω = 2πf)
E = NBA2πf
where;
f is the minimum frequency, measured in hertz (Hz)
f = E / (NBA2π)
f = 8 / (200 x 30 x 10⁻³ x 300 x 10⁻⁴ x 2 x 3.142)
f = 7.073 Hz
f = 7.1 Hz
Therefore, the minimum frequency of the coil is 7.1 Hz
Answer:
The ice melts mass is:
Explanation:
Kinetic Energy
Heat gained by ice= mass(g) x 80 cal
( 1 cal = 4.184 *10^7er or g cm^2/ sec^2)
Assuming no loss in heat, in the motion so both continue with temperature 0~C
To find so the mass (gm) of ice melted
