1. Resistor
2. Insulator
3. Current
4. Semiconductor
5. Conductor
Answer:
Explanation:
Given,
Red light wavelength = 633 nm
width of slit = 0.320 mm
distance,d = 2.60 m
Condition of first maximum
m = 1
Width of the first minima
Now, width of the central region
Answer:
21000 N
Explanation:
From the question given above, the following data were obtained:
Change in momentum = 105000 kg.m/s
Time = 5s
Force =?
Force is related to momentum and time according to the following formula:
Force = Change in momentum / time
With the above formula, we can calculate the force the white car experience during the collision. This can be obtained as illustrated below:
Change in momentum = 105000 kg.m/s
Time = 5s
Force =?
Force = Change in momentum / time
Force = 105000 / 5
Force = 21000 N
Thus, the white car experience a force of 21000 N during the collision.
U need to set up n solve the general eqn for simple harmonic motion:
x" = -(k/m)x
solution is x(t) = (x0)*cos(wt) + (v0/w)*sin(wt)
where w=sqrt(k/m), x0 is x-position at t=0 and v0 is vel at t=0
u already calculated f in Q.2 and w = 2*pi*f
x0 is 0 as it starts at eqm
v0 is given at 5.1
so u have x(t)
vel is given by x'(t) = (x0)*(-w)*sin(wt) + (v0/w)*w*cos(wt)
substitute t=0.32, x0=0, v0=5.1 n w in the above, u can solve for v at t=0.32.
(I'm lucky to have a computer ... It was only through the miracle of
modern digital technology that I was able to flip your photo right-
side-up to where I could read it.)
Here's how to figure out things like this:
The circle on the left side labeled ' <em>G</em> ' is the <em><u>G</u></em>enerator or battery
that powers this whole circuit and all the devices in it. In order for
any device to work, you need to be able to set your pencil down at
the top of the Generator, and find a path through the circuit and
through that device, where current can flow all the way around to
the bottom of the Generator. If you ever come to an open switch,
then current stops there, and you have to find another way through.
If the path you found takes you back to the bottom of the generator but
it doesn't go through one of the devices, then that device doesn't work.
Look at the picture. If you open switch S-4, then Device-4 can't work,
because current can't go through it from one end of the Generator to
the other end. But all of the other devices still work.
I can see 2 ways to turn off Device-3 with a single switch ... either
open switch S-5, or else open switch S-1. Unfortunately, I think
either way will shut off all 5 devices.