First, we calculate the mass of the sample:
mass = density x volume
mass = 8.48 x 112.5
mass = 954 grams
Now, we will calculate the mass of each component using its percentage mass, then divide it by its atomic mass to find the moles and finally multiply the number of moles by the number of particles in a mole, that is, 6.02 x 10²³.
Zinc mass = 0.37 x 954
Zinc mass = 352.98 g
Zinc moles = 352.98 / 65
Zinc moles = 5.43
Zinc atoms = 5.43 x 6.02 x 10²³
Zinc atoms = 3.27 x 10²⁴
Copper mass = 0.63 x 954
Copper mass = 601.02 g
Copper moles = 601.02 / 64
Copper moles = 9.39
Copper atoms = 9.39 x 6.02 x 10²³
Copper atoms = 5.56 x 10²⁴
Answer:
Explanation:
MnO₂(s) + 4 HCl(aq) = MnCl₂(aq) + 2 H₂O(l) + Cl₂
87 g 22.4 x 10³ mL
volume of given chlorine gas at NTP or at 760 Torr and 273 K
= 175 x ( 273 + 25 ) x 715 / (273 x 760 )
= 179.71 mL
22.4 x 10³ mL of chlorine requires 87 g of MnO₂
179.4 mL of chlorine will require 87 x 179.4 / 22.4 x 10³ g
= 696.77 x 10⁻³ g
= 696.77 mg .
(1)
At phase A, the water is fully solid, At phase C the water is fully liquid and at phase E the water is fully gas. At this ponts all the substance is in one state other than the fact that its molecules are getting more excited as they gain more energy. This is why there is an increase in temperatures. At the transition points water is changing phase and therefore at any point in between the transition not all water will be in the same phase.
(2)
Point F
This is because the solid water stops rising in temperatures and begins changing phase into liquid water. This is the highest temperatures that the solid water can attain without turning into liquid. You can see from the graph that the temperatures rise at this point levels off between point F and G
(3)
Point H
This is because the liquid water stops rising in temperatures and begins changing phase into gaseous form. This is the highest temperatures that the liquid water can attain without turning into gas/water vapor. You can see from the graph that the temperatures rise at this point levels off between point H and I.
(4)
The energy is increasing
You can see from the graph that energy is being absorbed by the water (due to increases in energy on the x-axis on the graph) but there is no corresponding rise in temperatures in y-axis. This means the energy begin absorbed is being used to change the phase of the water.
(5)
The water is changing phases
Because the energy absorbed is being used to change the phase of the liquid. The energy is being used to break the bonds between the molecules so the molecules become farther apart and causing a change in phase on the water. Therefore the vibrational moments of the molecules (responsible for rising in temperatures) remain the same over this latent phase. This energy absorbed to change phase is called latent energy/heat.
Learn More:
For more on change of phase of water check out;
brainly.com/question/2128466
brainly.com/question/13251064
#LearnWithBrainly
Its <span>c.chromatography is the process of separating solutions on the basis of their boiling points </span>
