The correct answer for the statement “All the scientific
theories used to explain the formation of the solar system are non-testable”. The
answers outdated, imaginative and unacceptable are wrong. These theories are
not proven and yet are not tested due to the complexity.
Answer:
Resistance =330 Ω
Tolerance = 33 Ω
Explanation:
see attached resistor color code table
The first stripe is orange, which means the leftmost digit is a 3.
The second stripe is orange , which means the next digit is a 3.
The third stripe is brown. Since brown is 1, it means add one zero to the right of the first two digits.
The resistance is:
orange-orange-brown= 330 Ω
The tolerance is:
The fourth color band indicates the resistor's tolerance. Tolerance is the percentage of error in the resistor's resistance.
silver is 10%
A 330 Ω resistor has a silver tolerance band.
<em>Tolerance = value of resistor x value of tolerance band </em>
= 330 Ω x 10% = 33 Ω
330 Ω stated resistance +/- 33 Ω tolerance means that the resistor could range in actual value from as much as 363 Ω to as little as 297 Ω.
Answer:
Friction
Explanation:
Friction is a force that slows down moving objects. If you roll a ball across a shaggy rug, you can see that there are lumps and bumps in the rug that make the ball slow down. The rubbing, or friction, between the ball and the rug is what makes the ball stop rolling. External Force is required.
The meter out circuit is the flow control circuit design that can most effectively control an overrunning load.
The meter-out circuit can be very accurate, but are not efficient. The meter-out circuit can control overrunning as well as opposing loads while the other one method must be used with opposing loads only. The choice of flown control valve method and the location of the flow control in the circuit are dependent on the type of application being controlled.
<h3>What is a Circuit ?</h3>
In electronics, a circuit is a complete circular conduit through which electricity flows. A simple circuit consists of conductors, a load, and a current source. The term "circuit" broadly refers to any continuous path via which electricity, data, or a signal might flow.
- The directional valve shifts, causing the actuator to move faster than pump flow can fill it due to an overrunning load. Oil is leaking from one side, whereas there is none on the other.
Hence, flow control circuit design that can best control an overrunning load is the opposing circuit
Learn more about Circuit here:
brainly.com/question/26064065
#SPJ4
Answer:
Explanation:
Given:
The area of the house 
The height of the house 
We need to find the volume of a typical house.
Solution:
We find the volume of the house by multiplying the area of the house and height of the house.
Area and height of the house are known, so we substitute these value in above equation.
Now we convert the unit from feet to meter.
Divide the volume by 3.2808 for 
Therefore, the volume of the house is 
