All categories

1 year ago

The flow control circuit design that can best control an overrunning load is the ____ circuit.

Physics

1 answer:

lara31 [8.8K]1 year ago

3 0

The meter out circuit is the flow control circuit design that can most effectively control an overrunning load.

The meter-out circuit can be very accurate, but are not efficient. The meter-out circuit can control overrunning as well as opposing loads while the other one method must be used with opposing loads only. The choice of flown control valve method and the location of the flow control in the circuit are dependent on the type of application being controlled.

<h3>What is a Circuit ?</h3>

In electronics, a circuit is a complete circular conduit through which electricity flows. A simple circuit consists of conductors, a load, and a current source. The term "circuit" broadly refers to any continuous path via which electricity, data, or a signal might flow.

The directional valve shifts, causing the actuator to move faster than pump flow can fill it due to an overrunning load. Oil is leaking from one side, whereas there is none on the other.

Hence, flow control circuit design that can best control an overrunning load is the opposing circuit

Learn more about Circuit here:

brainly.com/question/26064065

#SPJ4

You might be interested in

A plane is flying east when it drops some supplies to a designated target below. The supplies land after falling for 10 seconds.

Diano4ka-milaya [45]

solution:

As Given plane is flying in east direction.

It throws back some supplies to designated target.

Time taken by the supply to reach the target =10 seconds

g = Acceleration due to gravity = - 9.8 m/s²[Taken negative as object is falling Downwards]

As we have to find distance from the ground to plane which is given by d.

d = $\frac{1}{2}\times g\times t^2$

= $\frac{1}{2}\times (9.8) \times(100) =50\times 9.8=490$ meters

Distance from the ground where supplies has to be land to plane = Option B =490 meters

6 0

2 years ago

Read 2 more answers

cup of hot chocolate has a spoon in it. How does the heat move from the hot chocolate to the metal spoon handle?

serg [7]

The heat moves from the hot chocolate to the handle of the spoon by a process called thermal conduction.

It is the transfer of heat energy from one object to another when they are in contact with eachother.

Hope this answers your question.

5 0

2 years ago

a child is swinging on swing, describe what happens to both the kinectic energy and potential enegry of the child as she swings

Igoryamba

Answer:

The K.E is maximum when the child is at the vertical position and the P.E is maximum at the extreme deviated position from the vertical.

Explanation:

A child is swinging on swing up and down has both kinetic and potential energy.
The total mechanical energy of the system is conserved throughout the system. At any instant the total mechanical energy is given by,

E = K.E + P.E

The K.E is maximum when the child is at the vertical position.
The P.E is maximum at the extreme deviated position from the vertical.
And when K.E is maximum P.E becomes minimum and vice versa as per the law of conservation of energy.

5 0

2 years ago

Which is an example of convection

Brums [2.3K]

Heating A Pot Filled With Water

4 0

2 years ago

Read 2 more answers

4. According to Newton third law what is the action force? The swimmer pushes against the water the water pushes back on the swi

marshall27 [118]

A.The swimmer pushes the water
C. the walls force against the ball

3 0

2 years ago

Read 2 more answers