Answer:
4.163 m
Explanation:
Since the length of the bridge is
L = 380 m
And the bridge consists of 2 spans, the initial length of each span is
Due to the increase in temperature, the length of each span increases according to:
where
is the initial length of one span
is the temperature coefficient of thermal expansion
is the increase in temperature
Substituting,
By using Pythagorean's theorem, we can find by how much the height of each span rises due to this thermal expansion (in fact, the new length corresponds to the hypothenuse of a right triangle, in which the base is the original length of the spand, and the rise in heigth is the other side); so we find:
Explanation:
The magnetic needle of a compass lines up with Earth's magnetic poles.
Answer:
the car would arrive after 10 hr to Austin.
Explanation:
bus average from amarllo to austin = 60 miles per hour
time takne by bus to reach austin = 8 hr
automobile average from amarllo to austin = 60 miles per hour
from the information given in the question:
60 mph --- 8 h
48 mph --- x h
By using The inverse variation:
60 : 48 = x : 8
60* 8 = 48* x
480 = 48*x
x = 480/48
x = 10 h
the car would arrive after 10 hr to Austin.
The meter out circuit is the flow control circuit design that can most effectively control an overrunning load.
The meter-out circuit can be very accurate, but are not efficient. The meter-out circuit can control overrunning as well as opposing loads while the other one method must be used with opposing loads only. The choice of flown control valve method and the location of the flow control in the circuit are dependent on the type of application being controlled.
<h3>What is a Circuit ?</h3>
In electronics, a circuit is a complete circular conduit through which electricity flows. A simple circuit consists of conductors, a load, and a current source. The term "circuit" broadly refers to any continuous path via which electricity, data, or a signal might flow.
- The directional valve shifts, causing the actuator to move faster than pump flow can fill it due to an overrunning load. Oil is leaking from one side, whereas there is none on the other.
Hence, flow control circuit design that can best control an overrunning load is the opposing circuit
Learn more about Circuit here:
brainly.com/question/26064065
#SPJ4
You are sitting at the center of a large turntable at an amusement park as it is set spinning freely. You decide to crawl towards the edge of the turntable. Rotational speed will decrease
There is no external torque
hence , the angular momentum of the table is conserved
L (initial) = L ( final)
since , L = m*v*r
where
m = mass
v = velocity
r = radius
If the person is crawled towards the outer rim, then the rotational inertia of the turntable will increase. In order to conserve the angular momentum , its rotational speed will decrease as mass and radius cannot be altered .
To learn more about torque here :
brainly.com/question/19104073
#SPJ4
