Answer:
116 g
Explanation:
From the question given above, the following data were obtained:
Number of mole of calcium = 2.9 moles
Mass of calcium =.?
The mole and mass of a substance are related according to the following formula:
Mole = mass / molar mass
With the above formula, we can obtain the mass of calcium. This can be obtained as follow:
Number of mole of calcium = 2.9 moles
Molar mass of calcium = 40 g/mol
Mass of calcium =.?
Mole = mass / molar mass
2.9 = mass of calcium / 40
Cross multiply
Mass of calcium = 2.9 × 40
Mass of calcium = 116 g
Therefore, the mass of 2.9 moles of calcium is 116 g.
Enzymes catalyze the chemical reactions, they act upon the reaction substrates and speed up the reaction. Enzymes have active sites, the places where the reaction substrates interact with the enzyme bringing about the conversion of substrates to products. So, as the enzyme concentration increases the rate of reaction increases till a point where the rate is leveled off. The rate does not further increase, as the substrate might have become limiting at that point. All the available amount of substrate would have been associated with the active sites of the enzymes. So, at that point although there is enough catalyst, lack of substrate would limit the rate of reaction.
Answer:
d properties
i took a test on this before
<span>In each case, the same bond gets broken - the bond between the hydrogen and oxygen in an -OH group. Writing the rest of the molecule as "X"
</span>
The factors to consider
Two of the factors which influence the ionisation of an acid are:
<span>the strength of the bond being broken,the stability of the ions being formed.</span>
In these cases, you seem to be breaking the same oxygen-hydrogen bond each time, and so you might expect the strengths to be similar.
Answer:HNO₃ and NO³⁻ would not function as buffer
Explanation:
The buffer solution are usually prepared by using any weak acid (which would partially dissociate) and mixing this weak acid with its own conjugate base or any weak base (which would partially dissociate) and mixing with with its conjugate acid.
A buffer solution is a solution which resists change in pH of the solution.
Since nitric acid is a very strong acid and hence neither nitric acid HNO₃ or its conjugate base NO³⁻ anionb is suitable for the preparation of buffer solution.
HCO³⁻ is a weak acid and hence it can form a buffer solution with its conjugate base CO₃²-. so they can be used to form buffer.
C₂H₅COOH is a weak acid and hence it can also form buffer solution with its conjugate base.
So only HNO₃and NO³⁻ would not be able to form buffer
So option a is the answer.
