Answer:
(a). Z = 54.54 ohm
(b). R = 36 ohm
(c). The circuit will be Capacitive.
Explanation:
Given data
I = 2.75 A
Voltage = 150 V
rad = 48.72°
(a). Impedance of the circuit is given by
Z = 54.54 ohm
(b). We know that resistance of the circuit is given by
Put the values of Z & 
in above formula we get
R = 36 ohm
(c). Since the phase angle is negative so the circuit will be Capacitive.
Answer:
The last one, nicotine from tobacco
<span><span>Velocity is a vector, and the initial and final ones are in opposite directions.
There must have been acceleration in order to change the direction of motion.</span>
A) No. The initial and final velocities are the same.
This is all wrong, and not the correct choice.
It's "Yes", and the initial and final velocities are NOT the same.
B) Yes. The ball had to slow down in order to change direction.
This is poor, and not the correct choice.
The "Yes" is correct, but the explanation is bad.
Acceleration does NOT require any change in speed.
C) No. Acceleration is the change in velocity. The ball's velocity is constant.
This is all wrong, and not the correct choice.
It's "Yes", there IS acceleration, and the ball's velocity is NOT constant.
D) Yes. Even though the initial and final velocities are the same, there is a change in direction for the ball.
This choice is misleading too.
The "Yes" is correct ... there IS acceleration.
The change in direction is the reason.
The initial and final velocities are NOT the same. Only the speeds are.
</span>
Answer:
Explanation:
A combination of two controlled variables will make an experiment the most reliable.
Variables are the values that we take under any circumstance while doing an experiment so that we can keep on changing and get new results at the end.
It is important to have them in pair so that two values can be kept on changing in terms of any constant condition. This will help to get better results in over all experiment data.
