We are given with
M1 = 1.00 M
M2 = 0.300 M
V2 = 2.00 L
We are asked to get V1
Using material balance
M1 V1 = M2 V2
Substituting the given values
1.00 V1 = 0.300 M (2.00 L)
V1 = 0.600 L or 600 mL
THe volume needed is 600 mL<span />
Answer:
The main advantage would be that with the pouring temperature being much higher, there is very little chance that the metal will solidify in the mould while busy pouring. This will allow for moulds that are quite intricate to still be fully filled. The drawbacks, though, include an increased chance defects forming which relates to shrinkage (cold shots, shrinkage pores, etc). Another drawback includes entrained air being present, due to the viscosity of the metal being low because of the high pouring temperature.
Answer:
The new temperature of the nitrogen gas is 516.8 K or 243.8 C.
Explanation:
Gay-Lussac's law indicates that, as long as the volume of the container containing the gas is constant, as the temperature increases, the gas molecules move faster. Then the number of collisions with the walls increases, that is, the pressure increases. That is, the pressure of the gas is directly proportional to its temperature.
Gay-Lussac's law can be expressed mathematically as follows:
Where P = pressure, T = temperature, K = Constant
You want to study two different states, an initial state and a final state. You have a gas that is at a pressure P1 and at a temperature T1 at the beginning of the experiment. By varying the temperature to a new value T2, then the pressure will change to P2, and the following will be fulfilled:
In this case:
- P1= 2 atm
- T1= 50 C= 323 K (being 0 C= 273 K)
- P2= 3.2 atm
- T2= ?
Replacing:
Solving:
T2= 516.8 K= 243.8 C
<u><em>The new temperature of the nitrogen gas is 516.8 K or 243.8 C.</em></u>
Answer:
Table salt in salty water is Solute
Solvent in this solution is Water
Answer:
rise,cool..................