Answer:
t = 1.41 sec.
Explanation:
If we assume that the acceleration of the blocks is constant, we can apply any of the kinematic equations to get the time since the block 2 was released till it reached the floor.
First, we need to find the value of acceleration, which is the same for both blocks.
If we take as our system both blocks, and think about the pulley as redirecting the force simply (as tension in the strings behave like internal forces) , we can apply Newton's 2nd Law, as they were moving along the same axis, aiming at opposite directions, as follows:
F = m₂*g - m₁*g = (m₁+m₂)*a (we choose as positive the direction of the acceleration, will be the one defined by the larger mass, in this case m₂)
⇒ a = ( = g/5 m/s²
Once we got the value of a, we can use for instance this kinematic equation, and solve for t:
Δx = 1/2*a*t² ⇒ t² = (2* 1.96m *5)/g = 2 sec² ⇒ t = √2 = 1.41 sec.
Hello There!
It is Spring potential energy. Also called Elastic potential energy.
Hope This Helps You!
Good Luck :)
- Hannah ❤
Moment about the pivot must be equal for the seesaw to balance. Initially, the first cat and the bowl are at 2 m from the pivot.
The moment due to cat = 5.3*2 = 10.6 kg.m
The moment due to bowl = 2.5*2 = 5 kg.m
The unbalanced moment = 10.6 - 5 = 5.6 kg.m
Therefore, the 3.7 kg cat should stand at a distance x from the pivot in left to balance the 5.6 kg.m.
That is,
3.7*x = 5.6 => x = 5.6/3.7 = 1.5134 m to the left (on the side of the bowl)
On isolated ground receptacles, the metal yoke is not allowed to be integrally bonded to the equipment grounding terminal of the receptacle.
Any device with two distinct switches or receptacles is a duplex device. It can be shaped to fit a Decora opening or a typical duplex plate opening. It should be noted that they can be combination devices with a switch/outlet, switch/pilot light, etc.
Because of grounding connection removal and receptacle, it is utterly undesirable to connect the two bare equipment grounding conductors together directly.
The equipment grounding conductor associated with those circuits must be connected to the box when circuit conductors are terminated on equipment inside a metal box to prevent unneeded current discharge.
Learn more about grounding conductors here brainly.com/question/14886979
#SPJ4.