Answer:
Silver, 0.239 J/(g °C)
Explanation:
- The heat change is related to specific heat as given by the formula;
Heat change = mass of substance × specific heat × change in temperature
- Therefore; considering same amount of substance or equal masses and have the same initial temperature.
- The change in temperature will be inversely proportional to the specific heat.
- Therefore; the higher the specific heat lower the temperature change.
- Hence, the change in temperature will be highest for the substance with the lowest specific heat.
Therefore; the one that will increase in temperature the most is Silver
Answer:
It cannot conduct electricity, however adding salt or sugar will make the water have impurities/other substance making it easier to conduct electricity
Explanation:
Distilled water by itself does not contain impurities, thus, it cannot <em>conduct </em>electricity.
When you put salt in water, the water molecules pull the sodium and chlorine ions apart so they are floating freely, increasing the conductivity.
For more information, please refer to the internet :D
Have fun studying, and goodluck!
If you are satisfied with this answer, please rate it or give <u><em>brainliest.</em></u>
Answer:
Either B or C. Composition or the Distance from the Earth.
To determine the number of moles of carbon dioxide that is produced, we need to know the reaction of the process. For the reaction of HCl and sodium carbonate, the balanced chemical equation would be expressed as:
2HCl + Na2CO3 = 2NaCl + H2O + CO2
From the initial amount given of sodium carbonate and the relation of the substances from the balanced reaction, we calculate the moles of carbon dioxide as follows:
0.2 moles Na2Co3 ( 1 mol CO2 / 1 mol Na2Co3 ) = 0.2 moles CO2
Therefore, the amount in moles of carbon dioxide that is produced from 0.2 moles sodium carbonate would be 0.2 moles as well.
The balanced chemical reaction:
<span>Cu + 2AgNO3 = Cu(NO3)2 + 2Ag
</span>
We are given the amount of the reactants to be used for the reaction. These values will be the starting point of our calculations.
9.85 g Cu ( 1 mol Cu / 63.55 g Cu ) = 0.15 mol Cu
31.0 g AgNO3 ( 1 mol AgNO3 / 169.87 g AgNO3 ) = 0.18 mol AgNO3
The limiting reactant is AgNO3.
0.18 mol AgNO3 ( 1 mol Cu(NO3)2 / 2 mol AgNO3 ) (187.56 g / 1 mol) =16.88 g Cu(NO3)2
0.15 mol Cu - 0.18 mol AgNO3 ( 1 mol Cu / 2 mol AgNo3) = 0.06 mol Cu excess
<span>0.06 mol Cu ( 63.55 g Cu / 1 mol Cu ) = 3.81 g Cu excess</span>