The least amount of energy required to activate atoms or molecules to a state in which they can undergo a chemical reaction.
Answer:
Explanation:
Molarity is a measure of concentration in moles per liter.
The solution has a molarity of 1.2 M or 1.2 moles per liter. There are 4.0 moles of NaCl, the solute. We don't know the liters of solution, so we can use x.
- molarity= 1.2 mol/L
- moles of solute= 4.0 mol
- liters of solution =x
Substitute the values into the formula.
Since we are solving for x, we must isolate the variable. Begin by cross multiply (multiply the 1st numerator and 2nd denominator, then the 1st denominator and 2nd numerator.
x is being multiplied by 1.2 moles per liter. The inverse of multiplication is division, so divide both sides by 1.2 mol/L
The units of moles (mol) will cancel.
The original measurements both have 2 significant figures, so our answer must have the same. For the number we found, this is the tenths place.
The 3 in the hundredth place tells us to leave the 3 in the tenths place.
Approximately <u>3.3 liters of solution</u> are needed to make a 1.2 M solution with 4.0 moles of sodium chloride.
When you are asked a question like this, you can always ask yourself this question. Can I change it back after this change? For example, if you are burning wood, you cannot bring it back to wood after you burn it, therefore, it is a chemical change. However, if you boil and evaporate water, you can make the water condense again back into its liquid form. In this case, you cannot bring the tomato back to its raw state. Therefore, cooking raw tomatoes is a chemical change.
Explanation:
Inspite of having similar intermolecular forces, CS2 has a higher boiling point than CO2, since it has a greater molar mass. The potential energy of molecules reduces until a certain level as they get closer to each other. Although the polarity of both CO2 and CS2 are cancelled because of their linear structure.
It depends on the pH level of the water.