Please help me !! i’ll mark brainliest if you’re right!
1 answer:
You might be interested in
Answer:
He should run at least at 1.5 m/s
The diver will enter the water at an angle of 87° below the horizontal.
Explanation:
Hi there!
The position and velocity of the diver are given by the following vectors:
r = (x0 + v0x · t, y0 + v0y · t + 1/2 · g · t²)
v = (v0x, v0y + g · t)
Where:
r = position vector at time t
x0 = initial horizontal position
v0x = initial horizontal velocity
t = time
y0 = initial vertical position
v0y = initial vertical velocity
g = acceleration due to gravity (-9.8 m/s² considering the upward direction as positive)
v = velocity vector at time t
Please, see the attached figure for a description of the problem. Notice that the origin of the frame of reference is located at the jumping point so that x0 and y0 = 0.
We know that, to clear the rocks, the position vector r final (see figure) should be:
r final = ( > 5.0 m, -50 m)
So let´s find first at which time the y-component of the vector r final is - 50 m:
y = y0 + v0y · t + 1/2 · g · t²
-50 m = 2.1 m/s · t - 1/2 · 9.8 m/s² · t²
0 = -4.9 m/s² · t² + 2.1 m/s · t + 50 m
Solving the quadratic equation
t = 3.4 s
Now, we can calculate the initial horizontal velocity using the equation of the x-component of the position vector knowing that at t =3.4 the horizontal component should be greater than 5.0 m:
x = x0 + v0x · t (x0 = 0)
5.0 m < v0x · 3.4 s
v0x > 5.0 m / 3.4 s
v0x > 1.5 m/s
The initial horizontal velocity should be greater than 1.5 m/s
To find the angle at which the diver enters the water, we have to find the magnitude of the final velocity (vector vf in the figure). We already know the magnitude of the x-component of the vector vf, since the horizontal velocity is constant. So:
vfx > 1.5 m/s
Now, let´s calculate vfy:
vfy = v0y + g · t
vfy = 2.1 m/s - 9.8 m/s² · 3.4 s
vfy = -31 m/s
Let´s calculate the minimum magnitude that the final velocity will have if the diver safely clears the rocks. Let´s consider the smallest value allowed for vfx: 1.5 m/s. Then:
Then the final velocity of the diver will be greater or equal than 31 m/s.
To find the angle, we have to use trigonometry. Notice in the figure that the vectors vf, vfx and vy form a right triangle in which vf is the hypotenuse, vfx is the adjacent side and vfy is the opposite side to the angle. Then:
cos θ = adjacent / hypotenuse = vfx / vf = 1.5 m/s / 31 m/s
θ = 87°
The diver will enter the water at an angle of 87° below the horizontal.
Answer: B. The copper wire (resistance 0.1)
Explanation: When resistance is in parallel, voltage (V) is the same but current is different for every resistance. Current (i) is related to voltage and resistance (R) by <em>Ohm's Law</em>
i =
So, since both wires are in parallel, they have the same voltage but because the copper wire resistance is smaller than Nichrome wire, the first's current will be bigger.
Every resistor in a circuit dissipates electrical power (P) that is converted into heat energy. The dissipation can be found by:
P =
As current for copper wire is bigger than nichrome, power will be bigger and it will dissipate more heat.
In conclusion, the copper wire will dissipate more heat when connected in parallel.