The If a car is going round a curve , there is an acceleration because the direction of the velocity changes.
<h3>What is the direction of the velocity?</h3>
Now we know that if you throw the ball upwards, the motion is in opposite direction to gravity thus the ball is experiencing deceleration and the speed decreases. The velocity decreases and the acceleration is negative.
If the ball is coming down, then the ball is accelerated thus it speeds up and the direction of the acceleration is positive.
If a car is going round a curve, the vehicle is accelerating because the direction of the velocity changes even if its amount remains constant.
When a board is moving down a hill at 2 ms-1, it is experiencing an acceleration because the motion is in the same direction as gravity.
If a car is coming to a stop at a point, it experiences a deceleration and not an acceleration since the change of velocity with time is negative as the car comes to rest.
Learn more about acceleration:brainly.com/question/12550364
#SPJ1
The figure is showing a volume of 2.4 mL becuase it's feel 4 little segments.
Therefore, the answer is 2.4 mL.
Answer: The frequency heard will be f = 275.675Hz
Explanation: When an object emitting sound is moving, it occurs a phenomenon called Doppler shift or Doppler effect. What happens is that the sound gets higher when the moving object comes closer the observer and becomes lower after it passes, This change is due to the quantity of waves that passes through an area in an unit of time.
The formula to calculate the Doppler effect is as follows
f = () · f₀
f is the observed frequency;
c is the speed of sound;
Vs is velocity of the source;
f₀ is the emitted frequency of source;
Substituting and calculating,
f = · 300
f = 275.675 Hz
Thus, the frequency heard by the police officer is 275.675Hz.
Calm, sunny days with wind moving away from the center.
Answer:
Explanation:
Notice that this is a circuit with resistors R1 and R2 in parallel, connected to resistor R3 in series. It is what is called a parallel-series combination.
So we first find the equivalent resistance for the two resistors in parallel:
By knowing this, we can estimate the total current through the circuit,:
So approximately 0.17 amps
and therefore, we can estimate the voltage drop (V3) in R3 uisng Ohm's law:
So now we know that the potential drop across the parellel resistors must be:
10 V - 4.28 V = 5.72 V
and with this info, we can calculate the current through R1 using Ohm's Law: