Answer: see figure attached and explanation below.
Explanation:
1) Chemical equation (given):
Fe + CuCl₂ → Cu + FeCl₂
2) ΔHf reactants: -256 kJ/mol (given)
3) ΔHf products: - 321 kJ/mol (given)
4) ΔH reaction = ΔHf products - ΔHf reactants = - 321 kJ/mol - (- 256 kJ/mol) = - 65 kJ/mol
5) Conclusion:
i) Since ΔHf of products is less (more negative) than ΔHf of reactants, the reaction is exhotermic: the reaction released energy, which is the reason why the products content less potential energy than the reactants.
ii) Then, the energy diagram is the typical one of an exothermic reaction: the products start a certain potential energy level, the energy incrases until reaching the activation energy (the energy barrier to form the activated complex) and then energy decreases until a level below the energy of the reactants.
iii) See the attached figure with such kind of diagram showing the products at a lower level than the reactans
Answer:
Rem is used to measure biological risk, and rad is used to measure absorbed radiation.
Explanation:
<span>the chemical equation will be Ni(OH)2(s)------>heat---> NiO(s) + H2O(g)
</span><span>we know that the heat supplied to decompose the compound.In the result the product H2O is assumed to be in the vapor state so that is gas.
hope it helps
</span>
Answer:
The reaction would shift toward the reactants
When the reaction reach equilibrium the partial pressure of NH3 will be greater than 1atm
Explanation:
For the reaction:
2NH₃(g) ⇄ N₂(g) + 3H₂(g)
Where K is defined as:
As initial pressures of all 3 gases is 1.0atm, reaction quotient, Q, is:
As Q > K, <em>the reaction will produce more NH₃ until Q = K consuming N₂ and H₂.</em>
Thus, there are true:
<h3>The reaction would shift toward the reactants</h3><h3>When the reaction reach equilibrium the partial pressure of NH3 will be greater than 1atm</h3>
<em />