Plastics and polysaccharides are somewhat similar because they are both polymers. Polymers are a long chain of repeating units called monomers. Their difference, however, is the identity of their monomers. Plastics have hydrocarbons as monomers. Plastics with the monomer ethene is called polyethylene. For polysaccharides, their monomers are simple sugars.
<span> First you need to know how many isotopes there are of silicon, and its average atomic units (look at periodic table). Then make up a system of equations to solve for it. Theres 3 stable silicon isotopes (28, 29, 30) so you will need to have 3 equations. You must be given the percent abundance of at least one of the isotopes to solve because here I can only see 2 equations (numbered down below) set x = percent abundance of si-28 y = percent abundance of si-29 z = percent abundance of si-30 since all of silicon atoms account for 100% of all silicon: x + y + z = 100% = 1 therefore: 1) x = 1 - y - z You also have 2) 28x + 29y + 30z = average atomic mass you can substitute x so that equation becomes: 28 (1 - y - z) + 29y + 30z = average atomic mass See how you have 2 variables here? You cant go on until you know the value of one isotope already or you have given a clue which you can derive the third equation</span>
Answer:
88,7 mL of solution
Explanation:
Molarity (Represented as M) is an unit of chemical concentration that is defined as the ratio between moles of solute per liters of solution, that is:
Molarity = moles of solute / Liters of solution
If molarity of KCN solution is 0,0820M and moles of KCN are 7,27x10⁻³ moles:
0,0820M = 7,27x10⁻³ moles / Liters of solution
Liters of solution = 0,0887L = <em>88,7 mL of solution</em>
I hope it helps!
Where are the following elements to choose from?