mass of iron block given as
density of iron block is
now the volume of the iron piece is given as
Now when this iron block is complete submerged in oil inside the beaker the buoyancy force on the iron block will be given as
here we know that
= density of liquid = 916 kg/m^3
Now for the reading of spring balance we can say the spring force and buoyancy force on the block will counter balance the weight of the block at equilibrium
So reading of spring balance will be 16.45 N
Now for other scale which will read the normal force of the surface we can write that normal force on the container will balance weight of liquid + container and buoyancy force on block
So the other scale will read 36.47 N
Answer:
No, it is not proper to use an infinitely long cylinder model when finding the temperatures near the bottom or top surfaces of a cylinder.
Explanation:
A cylinder is said to be infinitely long when is of a sufficient length. Also, when the diameter of the cylinder is relatively small compared to the length, it is called infinitely long cylinder.
Cylindrical rods can also be treated as infinitely long when dealing with heat transfers at locations far from the top or bottom surfaces. However, it not proper to treat the cylinder as being infinitely long when:
* When the diameter and length are comparable (i.e have the same measurement)
When finding the temperatures near the bottom or top of a cylinder, it is NOT PROPER TO USE AN INFINITELY LONG CYLINDER because heat transfer at those locations can be two-dimensional.
Therefore, the answer to the question is NO, since it is not proper to use an infinitely long cylinder when finding temperatures near the bottom or top of a cylinder.
Answer:
Along path BC of the Otto cycle, heat transfer Qh into the gas occurs at constant volume, causing a further increase in pressure and temperature. This process corresponds to burning fuel in an internal combustion engine, and takes place so rapidly that the volume is nearly constant.
Answer:
i think it might be D or C
