In a chemical reaction, the mass of the products<span> is less than the mass of the reactants.
the first step in most stoichiometry problems is to <span>convert given quantities to moles.
Hope this helps! If it did, pls marky me brainly thank, and 5star me</span>
</span>
Answer:
C. 0.20 M Mg ion & 0.40 M Cl ion
Explanation:
MgCl₂ is a ionic salt which is dissociated as this
MgCl₂ → Mg²⁺ + 2Cl⁻
First of all, we have a solution of 200 mL, with [MgCl₂] = 0.6M
Molarity . volume = moles.
0.6 mol/l . 0.2l = 0.12 mol
MgCl₂ → Mg²⁺ + 2Cl⁻
0.12mol 0.12 0.24
This moles are also in 400mL of water, so the new concentration is
[Mg²⁺] = 0.12 m/0.6L = 0.2M
[Cl⁻] = 0.24 m/0.6L = 0.4M
Remember we initially have 200mL and then, we add 400 mL, so we supose aditive volume. (600mL)
Answer:
D. It predicts whether or not a reaction will be spontaneous.
Explanation:
<em>What does Gibbs free energy (ΔG) predict?
.</em>
A. It predicts what the rate of the reaction will be. NO. ΔG is a thermodynamical parameter and it is not related to the kinetics of the reaction.
B. It predicts how high the activation energy is. NO. ΔG is a thermodynamical parameter and it is not related to the kinetics of the reaction.
C. It predicts if entropy will increase or decrease. NO. ΔG depends on the entropy but not the other way around.
D. It predicts whether or not a reaction will be spontaneous. YES. If ΔG < 0 the reaction is spontaneous and if ΔG > 0 the reaction is not spontaneous.
Answer: The new volume be if you put it in your freezer is 1.8 L
Explanation:
To calculate the final temperature of the system, we use the equation given by Charles' Law. This law states that volume of the gas is directly proportional to the temperature of the gas at constant pressure.
Mathematically,
where,
are the initial volume and temperature of the gas.
are the final volume and temperature of the gas.
We are given:
Putting values in above equation, we get:
The new volume be if you put it in your freezer is 1.8 L
The steps to be followed while cleaning volumetric glassware are:
1. Remnants from the previous measurements are wiped off with the help of paper towel.
2. The glassware is then soaked overnight in warm soap solution.
3. Then before rinsing with tap water, the glassware are scrubbed with an appropriate brush.
4. After scrubbing, the glassware is rinsed thoroughly with tap water in order to make sure there are no traces of soap solution.
5. The glassware is then rinsed with de-ionized water and finally with the solution that would be used for the volumetric measurement.
