The statement “Only the “Conclusion” section discusses whether the original hypothesis was supported, and both sections suggest further research”, best describes the difference between analysis and conclusion.
Answer: Option 4
<u>Explanation:
</u>
In research, we do experiments and derive the results. Then, those results were analyzed by us. In this analysis part, we compare our results with the related results published elsewhere. Also, we correlate the similarities and point out the differences between our analysis and other reported results.
In conclusion part, we have to check hypothesis or it supported. And, we summarise our analysis and figure out the further research need to be done on that to improvise our research. So, the final statement is the correct option which best describes the difference between analysis and conclusion.
Answer:
89.4%
Explanation:
Initially, there is 5.0 of the acetanilide in 100 mL of water, then the solution is chilled at 0ºC. The solubility represents the amount that the solvent (water) can dissolve of the solute (acetanilide). So, at 0ºC, 100 mL of water can dissolve till 0.53 g of the compound, the rest will precipitate and will be recovered.
So, the mass that is recovered is 5.0 - 0.53 = 4.47 g
The percent recovery is:
(4.47/5)x100% = 89.4%
Answer:
The density of the ideal gas is directly proportional to its molar mass.
Explanation:
Density is a scalar quantity that is denoted by the symbol ρ (rho). It is defined as the ratio of the mass (m) of the given sample and the total volume (V) of the sample.
......equation (1)
According to the ideal gas law for ideal gas:
......equation (2)
Here, V is the volume of gas, P is the pressure of gas, T is the absolute temperature, R is Gas constant and n is the number of moles of gas
As we know,
The number of moles:
where m is the given mass of gas and M is the molar mass of the gas
So equation (2) can be written as:
⇒
⇒ ......equation (3)
Now from equation (1) and (3), we get
⇒ Density of an ideal gas:
⇒ <em>Density of an ideal gas: ρ ∝ molar mass of gas: M</em>
<u>Therefore, the density of the ideal gas is directly proportional to its molar mass. </u>