All categories

2 years ago

1.5 atm is the same pressure as... (1 atm 760 mmHg)

Chemistry

1 answer:

Darina [25.2K]2 years ago

3 0

<h3>Answer:</h3>

1100 mmHg

<h3>General Formulas and Concepts:</h3>

<u>Math</u>

<u>Pre-Algebra</u>

Order of Operations: BPEMDAS

Brackets
Parenthesis
Exponents
Multiplication
Division
Addition
Subtraction

Left to Right<u> </u>

<u>Chemistry</u>

Pressure

<u>Stoichiometry</u>

Using Dimensional Analysis

<h3>Explanation:</h3>

<u>Step 1: Define</u>

[Given] 1.5 atm

[Solve] mmHg

<u>Step 2: Identify Conversions</u>

1 atm = 760 mmHg

<u>Step 3: Convert</u>

[DA] Set up: $\displaystyle 1.5 \ atm(\frac{760 \ mmHg}{1 \ atm})$
[DA] Multiply/Divide [Cancel out units]: $\displaystyle 1140 \ mmHg$

<u>Step 4: Check</u>

<em>Follow sig fig rules and round. We are given 2 sig figs.</em>

1140 mmHg ≈ 1100 mmHg

You might be interested in

At what temperature and pressure can all three phases of water exist simultaneously?

Rzqust [24]

Thirty seven I think

8 0

2 years ago

Read 2 more answers

Write the half-reactions as they occur at each electrode and the net cell reaction for this electrochemical cell containing indi

AlexFokin [52]

Explanation:

The given cell reaction is as follows.

$In(s)| In^{3+}(aq) || Cd^{2+}(aq) | Cd(s)$

Hence, reactions taking place at the cathode and anode are as follows.

At anode ; Oxidation-half reaction : $In(s) \rightarrow In^{3+}(aq) + 3e^{-}$ ...... (1)

At cathode; Reduction-half reaction : $Cd^{2+}(aq) + 2e^{-} \rightarrow Cd(s)$ ....... (2)

Hence, balance the half reactions by multiplying equation (1) by 2 and equation (2) by 3.

Therefore, net cell reaction is as follows.

$2In(s) \rightarrow 2In^{3+}(aq) + 6e^{-}$

$3Cd^{2+}(aq) + 6e^{-} \rightarrow 3Cd(s)$

Net reaction: $2In(s) + 3Cd^{2+}(aq) \rightarrow 2In^{3+}(aq) + 3Cd(s)$

Thus, we can conclude that the overall cell reaction is as follows.

$2In(s) + 3Cd^{2+}(aq) \rightarrow 2In^{3+}(aq) + 3Cd(s)$

4 0

2 years ago

Which of the following is not part of the proper protocol for using acids and bases?

Anni [7]

Answer:

B.Add acid to water,not water to acid

Explanation:

they should not be mixed

8 0

2 years ago

A decrease in the magnitude of velocity is called

IceJOKER [234]

<span>The answer is deceleration. Acceleration is the general term to refer to the change in velocity. Acceleration = change in velocity / change in time. When you want to highlight the fact that the change in velocity is a decrease in the magnitude, you can use the term deceleration, which means that the acceleration is negative.</span>

3 0

3 years ago

Which characteristics affect ocean water’s temperature? Check all that apply. depth location mass salinity waves

RideAnS [48]

Answer:

Depth and location affect ocean water’s temperature.

Explanation:

The main source of heat for the oceans is solar radiation. That is, water is basically heated by the radiation of the Sun, which transmits energy to the surface. The ocean absorbs this energy and stores it. Seawater has high caloric capacity. This means that more energy and more time is needed to change or increase the water temperature, compared to the air temperature. Similarly, once the ocean heats up, it takes a long time for the water to completely release or lose that heat.

The temperature decreases to greater depth, because the amount of solar radiation is reduced. On the contrary, it is greater where there is greater energy or heat content.

The closer a place is to the equator, the solar energy will affect more vertically and with more intensity on it, so the warmer the temperatures will be. The further that point of the equator is found, the solar energy will reach it with a smaller angle. And if the point is near the poles, the sun's rays will arrive at a very small angle. This causes the temperature of the water of the oceans to vary depending on the earth's latitude, being higher in areas close to the equator and the tropics, and colder the closer to the poles or the further away from the temperate zones.

3 0

2 years ago

Read 2 more answers