Answer:
The answer is below
Explanation:
The separation technique is used for separating immiscible liquids.
When separating, the stopper has to be removed when draining the lower layer so as to prevent a vacuum. If vacuum is allowed, the draining rate will reduce and stop.
The liquid should be mixed by shaking the funnel and then opening the stopcock so as the vent out gases.
When near interface between the layers, you should set your eye level so that you do not drain up to the second layer.
After completely draining the first layer, the second layer should be collected in a new flask.
After mixing the solutions in a separatory funnel, the stopper should be removed and the liquid should be mixed thoroughly and the layers allowed to separate. When you get close to the interface between the layers, get eye level with the funnel and slow the draining until the first layer is collected. Switch to a new flask to collect the second layer.
Its A. because it measures the rate of the decay of the isotope
Weathering<span> breaks down and loosens the surface minerals of rock so they can be transported away by agents of erosion such as water, wind and ice. There are </span>two types<span> of </span>weathering<span>: </span>mechanical<span> and </span>chemical<span>. </span>Mechanical weathering<span> is the disintegration of rock into smaller and smaller fragments.</span>
