The purpose of using distilled water in the cuvette of the spectrophotometer is to calibrate the instrument. It is generally considered that distilled water shows zero absorbance and 100 % transmittance. So, to zero out the absorbance of compounds other than the analyte being determined, distilled water is used as a blank.
If the unknown being determined is prepared using ethanol as the base solution, the blank used must be ethanol. This is because absorbance if any from the solvent, ethanol must be zeroed out as when the measurement of the actual unknown is being made, the absorbance of the solvent does not interfere.
Attraction between a cation in one element and an anion in the other element
Answer:b. gravitational, kinetic, thermal
Explanation:
The above explains the mechanism of the core forming process on earth/planet.
It is believed that this process might has contributed significantly to a planet's early stages heating. The time when these core-forming event happened is thought to have been mainly completed very early when Earth was young . The type of this event rather than it being seen as a single catastrophic event, it is likely to have been as a result of contractions on the earth severally.
The addition of partially differentiated material from another giant impact the rate of this spasm , and it increases each time the planet's mass is to increased.
This is a little on the history of planetary evolution.
The pressure of the gas is expected to increase in accordance to Boyle's law.
<h3>What is Boyle's law?</h3>
Boyle's law states that, the volume of a given mass of gas is inversely proportional to its pressure at constant temperature.
By implication, when the piston is lowered and the volume of the gas is decreased, the pressure of the gas is expected to increase in accordance to Boyle's law.
Learn more about Boyle's law: brainly.com/question/1437490
The products for the complete combustion of a hydrocarbon in excess air is carbon dioxide and water. Any hydrocarbon when reacted with oxygen will always yield the said products. Incomplete combustion, on the other hand, yields carbon monoxide and water.
