The gas is in a rigid container: this means that its volume remains constant. Therefore, we can use Gay-Lussac law, which states that for a gas at constant volume, the pressure is directly proportional to the temperature. The law can be written as follows:
Where P1=5 atm is the initial pressure, T1=254.5 K is the initial temperature, P2 is the new pressure and T2=101.8 K is the new temperature. Re-arranging the equation and using the data of the problem, we can find P2:
So, the new pressure is 2 atm.
The answer is 24 J
F K =.25*8 N
= 2N
F = f k = 2 N
Since a = 0
W = f * s
2 N * 12 m = 24 J
The coefficient of friction is a ratio used to quantify the friction force among two gadgets when it comes to the everyday pressure this is keeping them collectively. The coefficient of friction is critical attention at some stage in material selection and floor requirement determination.
For instance, ice on steel has a low coefficient of friction – the 2 materials slide past each different without problems – whilst rubber on the pavement has an excessive coefficient of friction – the substances no longer slide past each other without difficulty.
The coefficient of friction is dimensionless and it does not have any unit. it is a scalar, meaning the direction of the force does not have an effect on the physical quantity. The coefficient of friction depends on the gadgets that are causing friction.
Learn more about the coefficient of friction here brainly.com/question/20241845
#SPJ4
The answer is methamphetamine
In the writing of ionic chemical formulas the value of each ion's charge is crossed over in the crossover rule.
Rules for naming Ionic compounds
- Frist Rule
The cation (element with a negative charge) is written first in the name then the anion(element with a positive charge) is written second in the name.
- Second rule
When the formula unit contains two or more of the same polyatomic ion, that ion is written in parentheses with the subscript written outside the parentheses.
Example: Sodium carbonate is written as Na₂CO₃ not Na₂(CO)₃
- Third rule
If the cation is a metal ion with a fixed charge then the name of the cation will remain the same as the (neutral) element from which it is derived (Example: Na+ will be sodium).
If the cation is a metal ion with a variable charge, the charge on the cation is indicated using a Roman numeral, in parentheses, immediately following the name of the cation (example: Fe³⁺ = iron(III)).
- Fourth rule
If the anion is a monatomic ion, the anion is named by adding the suffix <em>-ide</em> to the root of the element name (example: F = Fluoride).
The oxidation state of each ion is also important, thus in the crossover rule, the value of each ion's charge is crossed over.
Learn more about chemical formulas here:
<u>brainly.com/question/11995171</u>
#SPJ4