Answer:
y=x, x-axis, y=x, y-axis
Explanation:
Reflecting the figure across three axes just moves it from one quadrant to another. It does not map the figure to itself.
Reflecting across the line y=x moves it from quadrant II to IV or vice-versa. If it is in quadrant I or III, it stays there. So the sequence of reflections x-axis (moves from I to IV), y=x (moves from IV to II), x-axis (moves from II to III), y=x (stays in III) will not map the figure to itself.
However, the last selection will map the figure to itself. The initial (and final) figure location, and the intermediate reflections are shown in the attached. The figure starts and ends as blue, is reflected across y=x to green, across x-axis to orange, across y=x to red, and finally across y-axis to blue again.
Answer: He read 40% of the total time.
Step-by-step explanation:
As per given,
Total time he spent = 2 +1+2 = 5 hours
Number of hours he spent on reading = 2 hours
The percent of the total time he read =
i.e. The percent of the total time he read = 40%
Hence, he read 40% of the total time.
The derivative of a function may be used to determine whether the function is increasing or decreasing on any intervals in its domain. If f′(x) > 0 at each point in an interval I, then the function is said to be increasing on I. f′(x) < 0 at each point in an interval I, then the function is said to be decreasing on I.Intervals of increasing, decreasing or constant ALWAYS pertain to x-values. Do NOT read numbers off the y-axis. Stay on the x-axis for these intervals! Intervals of Increasing/Decreasing/Constant: Interval notation is a popular notation for stating which sections of a graph are increasing, decreasing or constant.A function f(x) increases on an interval I if f(b) ≥ f(a) for all b > a, where a,b in I. If f(b) > f(a) for all b>a, the function is said to be strictly increasing.The slope and y-intercept values indicate characteristics of the relationship between the two variables x and y. The slope indicates the rate of change in y per unit change in x. The y-intercept indicates the y-value when the x-value is 0.
I hope this helps