<h3>
Answer:</h3>
2.125 g
<h3>
Explanation:</h3>
We have;
- Mass of NaBr sample is 11.97 g
- % composition by mass of Na in the sample is 22.34%
We are required to determine the mass of 9.51 g of a NaBr sample.
- Based on the law of of constant composition, a given sample of a compound will always contain the sample percentage composition of a given element.
In this case,
- A sample of 11.97 g of NaBr contains 22.34% of Na by mass
A sample of 9.51 g of NaBr will also contain 22.345 of Na by mass
% composition of an element by mass = (Mass of element ÷ mass of the compound) × 100
Mass of the element = (% composition of an element × mass of the compound) ÷ 100
Therefore;
Mass of sodium = (22.34% × 9.51 g) ÷ 100
= 2.125 g
Thus, the mass of sodium in 9.51 g of NaBr is 2.125 g
Parantheses mean present of a subgroup or a group of polyatomic ions in a chemical reaction.
<u>Explanation:</u>
In a chemical reaction, sometimes, a compound may be composed of group of polyatomic ions with other ions. Some of the polyatomic ions are sulfate, carbonate, nitrate, hydroxide, bicarbonate, ammonia etc.
So these polyatomic ions are formed by combining two or more elements. Thus, if the number of polyatomic ions in a compound is more than one, then we use parathesis and write those polyatomic ions in it and write the number of polyatomic ions present in the compound as subscript of the parathesis.
For example, Fe₂(SO₄)₃
So here SO₄ is a polyatomic ion and in the compound 3 atoms of SO₄ is required to neutralize the compound and thus paranthesis is used. Thus, parantheses mean present of a subgroup or a group of polyatomic ions in a chemical reaction.
The metalloids are mostly concentrated in groups 14, 15, and 16. (Some simpler charts will show them as 4A, 5A, and 6A - take a look at the top of the periodic table your class uses to double-check).
If you like my answer, please vote me a 'brainliest' - trying to improve my rank :-)
Answer:
Heat and mass transfer of a LiBr/water absorption heat pump system (AHP) was experimentally studied during working a heating-up mode. The examination was performed for a single spiral tube, which was simulated for heat transfer tubes in an absorber. The inside and outside of the tube were subjected to a film flow of the absorption liquid and exposed to the atmosphere, respectively. The maximum temperature of the absorption liquid was observed not at the entrance but in the region a little downward from the entrance in the tube. The steam absorption rate and/or heat generation rate in the liquid film are not constant along the tube. Hence the average convective heat transfer coefficient between the liquid film flowing down and the inside wall of the tube was determined based on a logarithmic mean temperature difference between the tube surface temperature and the film temperature at the maximum temperature location and the bottom. The film heat and mass transfer coefficients rose with increasing Reynolds number of the liquid film stream.
Answer : The products of the acid-base reaction between 
and LiOH are, 
and 
Explanation :
Neutralization reaction : It is a type of chemical reaction in which an acid react with a base to give salt and water as a product that means it reacts to give a neutral solution. It is also known as acid-base reaction.
The acid-base reaction will be:
Therefore, the products of the acid-base reaction between and LiOH are, and
