The metals will start to rust lol. i think. because this messes up how the metals conduct the flow of the electricity.
Potential energy is highest at the top of the loop, and kinetic energy is highest at the bottom of the loop.
Answer:
Density is affected by volume and mass.
Explanation:
Density is defined as the quantity of mass per unit of volume, or expressed mathematically, d = m/v.
Solution:
The angle between the sling and the load is
So the tension in each sling can be calculated as
Where
M is the mass of the load
The Horizontal reaction on the sling will be inward.
After using the spreader, the new angle between sling and load is , the tension in the sling will be
=
The tension will be same as before in the sling move away through the spreader at an angle more than 90 degree the horizontal force will act opposite and will be outward
To determine the amplitude of a wave, you would need to know the : B. Maximum displacement of the wave from the equilibrium position
You can find out the displacement by counting the waves that is
written on the Graph
Hope this helps