Ask question

Ask question

All categories

2 years ago

12

After an initial race George determines that his car loses 35 percent of its acceleration due to air resistance travelling at 38

m/s on flat ground. Assuming that his car travels with a constant acceleration, calculate the maximum speed (Vm), in meters per second, his car can reach on flat ground?\

1 answer:

ddd [48]2 years ago

3 0

Answer:

64.2 m/s

Explanation:

We are given that

Speed ,v=38 m/s

We have to find the maximum speed when his car reach on flat ground.

Using dimensional analysis

$F_{res}\propto v^2$

If 35% acceleration reduced by F(res) at 38 m/s

Then, 100% acceleration can be reduced by F(res) at v' m/s

$\frac{F_1}{F_2}=\frac{v^2}{v'^2}$

$v'^2=\frac{F_2}{F_1}v^2$

$v'=v\sqrt{\frac{F_2}{F_1}}$

Substitute the values

$v'=38\times \sqrt{\frac{100}{35}}$

$v'=64.2 m/s$

Hence, the maximum speed when his car can reach on flat ground=64.2 m/s

You might be interested in

Two positive charges are equal. Which has more electric potential energy?

Xelga [282]

Electrostatic potential energy of a system of charge is given by

$U = \frac{kq_1q_2}{r}$

here we have

$q_1,q_2$ = two charges of different magnitudes

r = distance between charges

so here we can see that electrostatic potential energy will depends upon the product of two charges and inversely depends upon the distance between the two charges

So here we can say that the electrostatic potential energy of two charges will be same and equal to each other

7 0

2 years ago

Read 2 more answers

An 18.5-cm-diameter loop of wire is initially oriented perpendicular to a 1.5-T magnetic field. The loop is rotated so that its

nikdorinn [45]

Answer:

The average induced emf in the loop is 0.20 V

Explanation:

Given:

Radius of loop $r = \frac{d}{2} = 9.25 \times 10^{-2}$ m

Magnetic field $B = 1.5$ T

Change in time $\Delta t = 0.20$ sec

According to the faraday's law,

Induced emf is given by

$\epsilon = -\frac{\Delta \phi}{\Delta t}$

Where $\phi =$ magnetic flux

$\phi = BA\cos0$ ( here $\theta = 0$ )

Where $A = \pi r^{2}$

We neglect minus sign because it's shows lenz law

$\epsilon = \frac{B \pi r^{2} }{\Delta t}$

$\epsilon = \frac{1.5 \times 3.14 \times (9.25 \times 10^{-2} )^{2} }{0.20}$

$\epsilon = 0.20$ V

Therefore, the average induced emf in the loop is 0.20 V

4 0

2 years ago

Two parallel disks of diameter D 5 0.6 m separated by L 5 0.4 m are located directly on top of each other. Both disks are black

oksian1 [2.3K]

To solve this problem it is necessary to apply the concepts related to the Stefan-Boltzmann law which establishes that a black body emits thermal radiation with a total hemispheric emissive power (W / m²) proportional to the fourth power of its temperature.

Heat flow is obtained as follows:

$Q = FA\sigma\Delta T^4$

Where,

F =View Factor

A = Cross sectional Area

$\sigma =$ Stefan-Boltzmann constant

T= Temperature

Our values are given as

D = 0.6m

$L = 0.4m\\T_1 = 450K\\T_2 = 450K\\T_3 = 300K$

The view factor between two coaxial parallel disks would be

$\frac{L}{r_1} = \frac{0.4}{0.3}= 1.33$

$\frac{r_2}{L} = \frac{0.3}{0.4} = 0.75$

Then the view factor between base to top surface of the cylinder becomes $F_{12} = 0.26$ . From the summation rule

$F_{13} = 1-0.26$

$F_{13} = 0.74$

Then the net rate of radiation heat transfer from the disks to the environment is calculated as

$\dot{Q_3} = \dot{Q_{13}}+\dot{Q_{23}}$

$\dot{Q_3} = 2\dot{Q_{13}}$

$\dot{Q_3} = 2F_{13}A_1 \sigma (T_1^4-T_3^4)$

$\dot{Q_3} = 2(0.74)(\pi*0.3^2)(5.67*10^{-8})(450^4-300^4)$

$\dot{Q_3} = 780.76W$

Therefore the rate heat radiation is 780.76W

5 0

2 years ago

How are mountains and plateaus alike?

mr Goodwill [35]

I think its " both have level surfaces"

7 0

2 years ago

Read 2 more answers

Suppose that the collector is held at a small negative voltage with respect to the grid. Will the accelerated electrons reach th

Leona [35]

Answer:

B) Yes, but only those electrons with energy greater than the potential difference established between the grid and the collector will reach the collector.

Explanation:

In the case when the collector would held at a negative voltage i.e. small with regard to grid So yes the accelerated electrons would be reach to the collecting plate as the kinetic energy would be more than the potential energy that because of negative potential

so according to the given situation, the option b is correct

And, the rest of the options are wrong

3 0

2 years ago