Answer:
B) hyperbolic curve; saturated with substrate
Explanation:
Enzymatic kinetics studies the speed of enzyme catalyzed reactions. These studies provide direct information about the mechanism of the catalytic reaction and the specificity of the enzyme. The speed of a reaction catalyzed by an enzyme can be measured with relative ease, since in many cases it is not necessary to purify or isolate the enzyme. The measurement is always carried out under the optimal conditions of pH, temperature, presence of cofactors, etc., and saturating substrate concentrations are used. Under these conditions, the reaction rate observed is the maximum speed (Vmax). The speed can be determined either by measuring the appearance of the products or the disappearance of the reagents.
Following the rate of appearance of product (or disappearance of the substrate) as a function of time, the so-called reaction progress curve is obtained, or simply, the reaction kinetics. This curve is represented by a hyperbolic curve
Answer:
specific heat
Explanation:
please like,rate and tag as brainliest
Answer:
You Need to put in the picture
Explanation:
I cant see it
The answer is A. Isotopes only differ in the number of neutrons in the nucleus of their atoms. Otherwise, all other subatomic particles are the same. The isotope with the more neutrons in its nucleus is therefore, heavier (have higher mass number). They share the same chemical properties but have slight physical differences such as boiling points with the heavier element having a slightly higher boiling point that the lighter element.
I believe the correct answer is the first option. To increase the molar concentration of the product N2O4, you should increase the pressure of the system. You cannot determine the effect of changing the temperature since we cannot tell whether it is an endothermic or an exothermic reaction. Also, decreasing the number of NO2 would not increase the product rather it would shift the equilibrium to the left forming more reactants. The only parameter we can change would be the pressure. And, since NO2 takes up more space than the product increasing the pressure would allow the reactant to collide more forming the product.
