Answer:
b. oxygen side being slightly negative and the hydrogen side being slightly positive.
Explanation:
The water molecule is a polar molecule, that is to say that its distribution of electronic density is different throughout the molecule.
In this way, in the water molecule there is a negative partial charge towards the oxygen atom and a positive partial charge towards the hydrogen atom.
This polar characteristic of the water molecule allows ions and other molecules to exhibit water solubility and is widely used in chemical reactions.
If it is not an isotope then it has around 21 neutrons
Answer:
Weigh the empty crucible, and then weigh into it between 2 g and 3 g of hydrated copper(II) sulphate. Record all weighings accurate to the nearest 0.01 g.
Support the crucible securely in the pipe-clay triangle on the tripod over the Bunsen burner.
Heat the crucible and contents, gently at first, over a medium Bunsen flame, so that the water of crystallisation is driven off steadily. The blue colour of the hydrated compound should gradually fade to the greyish-white of anhydrous copper(II) sulfate. Avoid over-heating, which may cause further decomposition, and stop heating immediately if the colour starts to blacken. If over-heated, toxic or corrosive fumes may be evolved. A total heating time of about 10 minutes should be enough.
Allow the crucible and contents to cool. The tongs may be used to move the hot crucible from the hot pipe-clay triangle onto the heat resistant mat where it should cool more rapidly.
Re-weigh the crucible and contents once cold.
Calculation:
Calculate the molar masses of H2O and CuSO4 (Relative atomic masses: H=1, O=16, S=32, Cu=64)
Calculate the mass of water driven off, and the mass of anhydrous copper(II) sulfate formed in your experiment
Calculate the number of moles of anhydrous copper(II) sulfate formed
Calculate the number of moles of water driven off
Calculate how many moles of water would have been driven off if 1 mole of anhydrous copper(II) sulfate had been formed
Write down the formula for hydrated copper(II) sulfate.
#*#*SHOW FULLSCREEN*#*#
Explanation:
Answer:
1 and 3
Explanation:
The vertical columns (groups) of the periodic table are arranged such that all its elements have the same number of valence electrons. All elements within a certain group thus share similar properties.
Answer:
CH3 - CH2 - NH - C(CH3)3
Explanation:
The 1HNMR is the acronym for Proton nuclear magnetic resonance and it is used in chemistry or Chemical laboratory for the analysis and identification of compounds.
In order to be able to answer the question accurately you have to have the tables containing all the values for chemical shift. The Chemical shift is measured in ppm and it occur due to Resonance frequency variation.
From the table, a singlet at 1.15 ppm (9H) is - C(CH3)3.
A singlet at d 0.9 ppm (1H) shows the presence of a secondary amine group, that is -R2NH group.
A triplet at 1.10 ppm (3H) shows that we have;
CH3- CH2-
A quartet at 2.6 ppm (2H) shows that we have;
-CH2 - CH3.
Therefore, joining all together we have;
CH3 - CH2 - NH - C(CH3)3.
Kindly check attached file for the picture of the structure.