Answer:
Explanation:
Dear Student, this question is incomplete, and to attempt this question, we have attached the complete copy of the question in the image below. Please, Kindly refer to it when going through the solution to the question.
To objective is to find the:
(i) required heat exchanger area.
(ii) flow rate to be maintained in the evaporator.
Given that:
water temperature = 300 K
At a reasonable depth, the water is cold and its temperature = 280 K
The power output W = 2 MW
Efficiency = 3%
where;
However, from the evaporator, the heat transfer Q can be determined by using the formula:
Q = UA(L MTD)
where;
Also;
LMTD = 4.97
Thus, the required heat exchanger area A is calculated by using the formula:
where;
U = overall heat coefficient given as 1200 W/m².K
The mass flow rate:
-1- was created in the 1600 by william gilbert
-2-When the charge is positive, electrons in the metal of the electroscope are attracted to the charge and move upward out of the leaves. This results in the leaves to have a temporary positive charge and because like charges repel, the leaves separate. When the charge is removed, the electrons return to their original positions and the leaves relax
3-
An electroscope is made up of a metal detector knob on top which is connected to a pair of metal leaves hanging from the bottom of the connecting rod. When no charge is present the metals leaves hang loosely downward. But, when an object with a charge is brought near an electroscope, one of the two things can happen.
Answer:
lipids are insoluble in water which is why lipids are often found in biological membranes and other waterproof coverings.
Answer:
B. Steam burns the skin worse than hot water because the latent heat of vaporization is released as well.
Explanation:
It is given that both steam and the boiling water when in contact with the skin cools down from 100 to 34 degrees Celsius.
For any substance of mass m, the heat required to change the temperature by is (S.I. unit = Joules).
where C, the specific heat capacity is the same and a constant for both the condensed steam and the boiling water.
But, there is a "hidden" energy (heat) released by the steam called latent heat
(given by mL, L = specific latent heat) which allows the phase transition (gas to liquid). While both of them are at the same temperature, their energy (heat) is different, which is why steam causes burns worse than boiling water
Answer:
. always start on the north pole and terminate (end) on the South Pole
Explanation: