Answer:
5. Is greater than mg, always
Explanation:
If the cone has an inclination of angle β, the sum of forces will be:
x-axis (centripetal axis):
N*sin β = m*ax where ax is the centripetal acceleration
y-axis:
N*cos β - m*g = m*ay where ay is the vertical acceleration. If the block starts falling down, ay will be negative. If the block starts sliding up, ay will be positive. If the block does not move up nor down, ay=0.
Solving for N:
If ay is positive or zero, N will be greater than mg. If ay is negative, N will be less than mg.
If the block is sliding along a horizontal circular path (not up, nor down), ay = 0, so N will always be greater than mg.
Answer:
New moment of inertia will be
Explanation:
It is given initially angular velocity
Moment of inertia
Angular momentum is equal to
Now angular velocity is decreases to
As we know that angular momentum is conserved
So
So new moment of inertia will be
p=mv so wouldn't u multiply them?
Answer:
1.-E=1000N/C to the LEFT
2.-The electric field inside a conductor in electrostatic state is always zero (conductor proprieties).
3.-The voltmeter read 0V as differential voltage between two points from the conductor
Explanation:
1.The electric field inside the conductor must be zero (conductor proprieties). Then the charges create a electric field equal an opposite to the external electric field. In other words E=1000N/C to the LEFT
2. The electric field inside a conductor in electrostatic state is always zero. As shown in the figure the electric field induced by the charges in the sphere surface cancelled the EXTERN electric field.
3.If the Electric field inside the conductor is zero, that means that the Voltage in the hole conductor is constant (conductor proprieties). In other words the the voltmeter read 0v as differential voltage between two points from the conductor.
Complete question is;
Does the galvanometer deflect to the left or the right when
a) the magnet is being pushed in
b) the magnet is being pulled out
c) the magnet is being held steady?
Answer:
Option A - when the magnet is being pulled out
Explanation:
Faraday’s law of electromagnetic induction states that: “Voltage is induced in a circuit whenever relative motion exists between the conductor and the magnetic field, and the magnitude of the voltage will be proportional to the rate of change of the flux”.
Now, applying it to the question, When the magnet is moved towards the sensitive center of the galvanometer and then pulled out, the needle of the galvanometer will deflect away from its center position in one direction only but when it is held steady, the needle of the galvanometer will return back to zero.