This problem is describing a gas mixture whose mole fraction of hexane in nitrogen is 0.58 and which is being fed to a condenser at 75 °C and 3.0 atm, obtaining a product at 3.0 atm and 20 °C, so that the removed heat from the system is required.
In this case, it is recommended to write the enthalpy for each substance as follows:
Whereas the specific heat of liquid and gaseous n-hexane are about 200 J/(mol*K) and 160 J/(mol*K) respectively, its condensation enthalpy is 31.5 kJ/mol, boiling point is 69 °C and the specific heat of gaseous nitrogen is about 29.1 J/(mol*K) according to the NIST data tables and 
and 
are the mole fractions in the gaseous mixture. Next, we proceed to the calculation of both heat terms as shown below:
It is seen that the heat released by the nitrogen is neglectable in comparison to n-hexanes, however, a rigorous calculation is being presented. Then, we add the previously calculated enthalpies to compute the amount of heat that is removed by the condenser:
Finally we convert this result to kJ:
Learn more:
Answer:
The equation for molarity is moles/liter for the first question you would do 0.256/0.143 liters to get 1.790 mol/L
Explanation:
The second problem you would do need to find the moles of NaCl which you would do by doing 4.89 g/58.44g/mol= 0.08367 then do 0.08367/0.600= 0.139 mol/L
The third problem would be the same steps as the second one.
The fourth problem would be (0.460M)(5.50L)= 2.53 moles
Answer:
20.9%
Explanation:
I took the test i hope this helps:)
<h2>Question:</h2>
- A solution that is able to dissolve additional solute is best described as _____.
<h2>Answer:</h2>
<h2>D.) Unsaturated </h2>
- <u>Unsaturated</u> means the substance is poured into the solvent that can be dissolved. It is a solution (with less solute than the saturated solution) that completely dissolves, leaving with no remaining substances.
<h2>For example:</h2>
- If you were to pour olive oil into a glass of water, it will dissolve, so it is <u>unsaturated</u>.
_________
#LetsStudy
Workplace Hazardous Materials Information System is the answer to this question. Hope it helps :)
