Since volume and temperature are constant, this means that pressure and <u>number of moles</u> are <u>directly </u>proportional. the sample with the largest <u>number of moles</u> will have the <u>high </u>pressure.
Since, the ideal gas equation is also called ideal gas law. So, according to ideal gas equations,
PV = nRT
- P is pressure of the sample
- T is temperature
- V is volume
- n is the number of moles
- R is universal gas constant
At constant volume and temperature the equation become ,
P ∝ nR
since, R is also constant. So, conclusion of the final equation is
P ∝ n
The number of moles and pressure of the sample is directly proportion. So, on increasing number of moles in the sample , pressure of the sample also increases.
learn about ideal gas law
brainly.com/question/4147359
#SPJ4
The answer would be electronegativity
Answer:
In physics and chemistry, ionization energy or ionisation energy is the minimum amount of energy required to remove the most loosely bound electron of an isolated neutral gaseous atom or molecule.
Explanation:
Answer:
See explanation and image attached
Explanation:
Alkenes undergo hydrogenation to give the corresponding alkanes. Where the structure of the original alkene is unknown, we can deduce the structure of the alkene from the structure of the products obtained when it undergoes various chemical reactions.
Now, the fact that we obtained 2-methylhexane upon hydrogenation and the two compounds had different heats of hydrogenation means that the two compounds were geometric isomers. The original compounds must have been cis-2-methyl-3-hexene and trans-2-methyl-3-hexene.
When reacted with HCl, the same compound C7H15Cl is formed because the stereo chemistry is removed.
However, we know that the trans isomer is more stable than the cis isomer hence the cis isomer always has a higher heat of hydrogenation than the trans isomer. Thus X is cis-2-methyl-3-hexene.
Answer:
The correct statement is that the point of initial resistance is the level of depression that will fill the pipette with the desired volume of solution.
Explanation:
The pipette can be otherwise stored vertically or horizontally, this has nothing to do with the operation, and before the operation, the dial needs to be set. Also, the plastic pipette tip should not be ejected at all, thus, no new disposable plastic tip is required for each sample.
The correct statement is that the point of initial resistance is the level of depression that will fill the pipette with the desired volume of solution.
