Answer:
<em>Part A</em><em>:</em>
a) If the wavelength of the light is decreased the fringe spacing Δy will decrease.
<em>Part B</em><em>:</em>
b) If the spacing between the slits is decreased the fringe spacing Δy will increase.
<em>Part C</em><em>:</em>
a) If the distance to the screen is decreased the fringe spacing will decrease.
<em>Part D</em><em>:</em>
The dot in the center of fringe E is farther from the left slit than from the right slit.
Explanation:
In the double-slit experiment there is a clear contrast between the dark and bright fringes, that indicate destructive and constructive interference respectively, in the central peak and then is less so at either side.
The position of bright fringes in the screen where the pattern is formed can be calculated with
- m is the order number.
- is the wavelength of the monochromatic light.
- L is the distance between the screen and the two slits.
- d is the distance between the slits.
- Part A: a) In the above equation for the position of bright fringes we can see that if the wavelength of the light is decreased the overall effect will be that the fringes are going to be closer. That means that the fringe spacing Δy will decrease.
- Part B: b) In the above equation for the position of bright fringes we can see that if the spacing between the slits d is decreased the fringes are going to be wider apart. That means the fringe spacing Δy will increase.
- Part C: a) In the above equation we can see that if the distance to the screen L is decreased the fringes are going to be closer. That means the fringe spacing Δy will decrease.
- Part D: We are told that the central maximum is the fringe C that corresponds with m=0. That means that fringe E corresponds with the order number m=2 if we consider it to be the second maximum at the rigth of the central one. To calculate how much farther from the left slit than from the right slit is a dot located at the center of the fringe E in the screen we use the condition for constructive interference. That says that the path length difference Δr between rays coming from the left and right slit must be
We simply replace the values in that equation :
The dot in the center of fringe E is farther from the left slit than from the right slit.
To solve this problem we will use the Ampere-Maxwell law, which describes the magnetic fields that result from a transmitter wire or loop in electromagnetic surveys. According to Ampere-Maxwell law:
Where,
B= Magnetic Field
l = length
= Vacuum permeability
= Vacuum permittivity
Since the change in length (dl) by which the magnetic field moves is equivalent to the perimeter of the circumference and that the electric flow is the rate of change of the electric field by the area, we have to
Recall that the speed of light is equivalent to
Then replacing,
Our values are given as
Replacing we have,
Therefore the magnetic field around this circular area is
Position is measured in meters (m), so it is a base quantity.
<h3>What is base quantity?</h3>
A base or fundamental quantity is a physical quantity, in which other quantities are derived from.
Example of fundamental quantities;
- Mass
- Length (position)
- Time
- Temperature
- Amount of substance
<h3>What is a derived quantity?</h3>
Derived quantities are those quantities obtained or expressed from fundamental quantities.
Example of derived quantities;
- Speed
- Acceleration
- Volume
- Area
- Density, etc
Thus, we can conclude that position measured in meters (m) is a base quantity.
Learn more about base quantities here: brainly.com/question/14480063
#SPJ1
Answer:ball, ramp, and angle
Explanation: these are the three things that are controls because you can control them
Each stream in a drainage system drains into a certain area. In a drainage basin the water falling in the basin drain will fall into the same stream. A drainage divides drawing basin from other drainage basins