Measuring spoons are used when measuring less than 1/4 cup
Explanation:
One way of classifying stars is by their temperature .
or
Science strives to be able to describe how stars and planets form and evolve. This requires theories to describe the processes which include:
Star and planet formation
Star and planet composition
Stellar and solar system evolution
The nuclear processes happening inside stars
The scientific method means that all theories are put to the test. By measuring or calculating the temperature, age and composition of other planets and stars the theories can be tested. If observed values of these parameters are not predicted by theories, then the theories are wrong and need to be revised or replaced.
I believe the answer is D
After reading this whole question, I feel like I've already
earned 5 points !
-- Two satellites at the same distance, different masses:
The forces of gravity between two objects are directly
proportional to the product of the objects' masses. In
other words, the gravitational forces between the Earth
and an object on its surface are proportional to the mass of
the object. In other words, people with more mass weigh more
on the Earth, and the Earth weighs more on them.
If the satellites are both at the same distance from Earth,
then the Earth pulls on the one with more mass with greater
force, and also the one with more mass pulls on the Earth
with greater force.
-- Two satellites with the same mass, at different distances:
The forces of gravity between two objects are inversely
proportional to the square of the distance between them.
In other words, the gravitational
forces between the Earth
and an object are inversely proportional
to the square of
the distance between the object and the center of the Earth.
If
the satellites both have the same mass, then the Earth
pulls on the nearer one with greater force, and also the
nearer one pulls on the Earth with greater force.
-- Resistor in a circuit when the voltage changes:
The resistance depends on how the resistor was manufactured.
Its resistance is marked on it, and doesn't change. It remains
the same whether the voltage changes, the current changes,
the time of day changes, the cost of oil changes, etc.
If you increase the voltage in the circuit where that resistor is
installed, the current through the resistor increases. If the current
remains constant, then you can be sure that somebody snuck over
to your circuit when you weren't looking, and they either installed
another resistor in series with the original one to make the total
resistance bigger, or else they snipped the original one out of the
circuit and quickly connected one with more resistance in its place.
= (18 x 10^-6 /°C)(0.125 m)(100° C - 200 °C)
= -0.00225 m
New length = L + ΔL
= 1.25 m + (-0.00225 m)
= 1.248
D
