Answer:
The water usually rushes back too enthusiastically, causing a splash – and the bigger the rock, the bigger the splash. The splash then creates even more ripples that tend to move away from where the rock went into the water.
<h2>Circular path i.e 1</h2>
Explanation:
If the driver steer into circular path , the acceleration of car will be
acceleration = velocity²/radius of circle
Because the velocity and radius of circle are both constant at all points . Thus the acceleration will also remain constant .
In case 3 and 4 , the radius of path changes . Because velocity is constant . Therefore the acceleration will not remain constant
The angular speed is decreasing and direction of rotation clockwise of the rod immediately after time t.
<h3>
</h3><h3>What is angular speed ?</h3>
The rate of change of angular displacement is defined as angular speed. It is stated as follows:
ω = θ t
Where,
θ is the angle of rotation,
t is the time
ω is the angular velocity
The torque is found as;l
If the force is acting on the rod from the three point is the same, the value of the torque is depends upon the radius or the perpendicular distance.
The perpendicular distance of the right force is grater. Hence, the force acting on the right side is more, and the rod will rotate clockwise.
Both the forces are acting downwards. Thus, the resultant force is the less due to which the speed is increasing.
Hence, the angular speed is decreasing and direction of rotation clockwise of the rod immediately after time t.
To learn more about the angular speed, refer to the link;
brainly.com/question/9684874
#SPJ1
Answer:
option 1
Explanation:
i just used the SOH CAH TOA, and since the given is tan=opposite/adjacent, that should be the answer
“Don't hand that holier than thou line to me” is what the asymptote
said to the removable discontinuity.
The distance between the
curve and the line where it approaches zero as they tend to infinity is the line in the asymptote
of a curve. This is unusual for modern authors but in some
sources the requirement that the curve may not cross the line infinitely often
is included.
The point that does not fit the rest of the graph or is
undefined is called a removable discontinuity. By filling in a single
point, the removable discontinuity can be made connected.
