Sound waves are known to be the one that's not considered as a type of electromagnetic energy. As for microwaves and x-rays, they tend to share the same frequencies that can be considered as electromagnetic, and sound waves have a different frequency than them.
Answer:
10 ms⁻¹
Explanation:
The amount of momentum that an object has is dependent upon two factors
- mass of the moving object
- speed of motion
In terms of an equation,
Momentum (P) = Mass(m)×velocity(v)
P = m×v
600 = 60 × v ⇒ v = 10 ms⁻¹
Answer:
W₂= 10000 N
Explanation:
Pascal´s Principle can be applied in the hydraulic press:
If we apply a small force (F1) on a small area piston A1, then, a pressure (P) is generated that is transmitted equally to all the particles of the liquid until it reaches a larger area piston and therefore a force (F2) can be exerted that is proportional to the area (A2) of the piston:
Pressure is defined as the force (F) applied per unit area (A)
P=F/A (N/m²)
P1=P2
Equation (1)
Data
W₁ = weight sits on the small piston
F₁ = W₁= 500 N
A₁ = 2.0 cm²
A₂ = 40 cm²
Calculation of the weight (W₂) can the large piston support
We replace data in the equation (1)
F₂ = 10000 N
W₂= F₂= 10000 N
Answer:
n = 4 x 10¹⁸ photons
Explanation:
First, we will calculate the energy of one photon in the radiation:
where,
E = Energy of one photon = ?
h = Plank's Constant = 6.625 x 10⁻³⁴ J.s
c = speed of light = 3 x 10⁸ m/s
λ = wavelength of radiation = 567 nm = 5.67 x 10⁻⁷ m
Therefore,
E = 3.505 x 10⁻¹⁹ J
Now, the number of photons to make up the total energy can be calculated as follows:
<u>n = 4 x 10¹⁸ photons</u>
In a series circuit . . .
There is only one path for current to take.
All the way from one terminal of the power supply, through all of
the lights, computers, vending machines, air conditioners and
everything else in the building, to the other terminal of the electric
supply. One path !
So the current for EVERY device has to flow through ALL of them,
because that's the only path there is.
If any ONE device in the building was turned off, burned out, or
unplugged from the outlet, then there would be NO PATH for the
current, and everything in the building would lose power !
Not a very convenient way to operate a house or a building.