The order of the positive and negative feedback loops are positive, positive, negative, positive, positive, negative.
<h3>
What is a feedback loop?</h3>
A system component known as a feedback loop is one in which all or a portion of the output is used as input for subsequent actions. A minimum of four phases comprise each feedback loop. Input is produced in the initial phase. Input is recorded and stored in the subsequent stage. Input is examined in the third stage, and during the fourth, decisions are made using the knowledge from the examination.
Both negative and positive feedback loops are possible. Insofar as they stay within predetermined bounds, negative feedback loops are self-regulating and helpful for sustaining an ideal condition. One of the most well-known examples of a self-regulating negative feedback loop is an old-fashioned home thermostat that turns on or off a furnace using bang-bang control.
To learn more about feedback loop, visit:
brainly.com/question/11312580
#SPJ4
The answer is letter b, the rotor will jam. It is because if there are too many washers, it will be overcrowded, making the rotor to jam in it, where this will lead the motor to dysfunction or not function properly. It is best not to place too many washers in the end of the shaded pole motor shaft to prevent further complications.
Answer:
The entire cart/hanging mass system follows the same law, ΣF = ma. This means that plotting force vs. acceleration yields a linear relationship (of the form y = mx).
Answer:
D
Explanation:
Ball A is a non positively charged non metal while ball B is metal ball.
Given: The ball B positive charge of small magnitude
To prove: Balls will attract each other
IN this condition because of induction negative charges on the sphere B move to the side closer to sphere A,(induction charging) while the positive charges move to the side further away from sphere A. The polarization of charge on B will cause a greater attractive force than the repulsion of the like charges.
Hence the correct answer will be D .
Correct answer choice is :
B) Upwarped
Explanation:
An upwarped mountain is a mountain consisting of a large area of the Earth's coat that has led smoothly upward without much visible deformation and normally including sedimentary, igneous, and metamorphic rocks. Sedimentary rocks are set down in layers called beds or layers. A bed is described as a layer of rock that has a similar lithology and character. Beds form by the removal of layers of sand on top of each other.
