The proton has two adjacent protons, so it splits into three peaks, a triplet. The proton has three adjacent protons, so it splits into four peaks, a quartet.
Answer:
0.4M NaOH
Explanation:
Molarity, M, is an unit of concentration widely used defined as the ratio between moles of solute (In this case, NaOH) and volume of solution in liters.
As the solution contains 2 moles of NaOH-Moles of solute- in 5L of solution, the molarity is:
2 moles NaOH / 5L =
<h3>0.4M NaOH</h3>
Answer:
the uses of exothermic reactions are:
1) lighting of stove
2) self heating cans
3) hand warmers
4) in some case exothermic process can be used to cook food such as rice (by adding calcium oxide to water heat is evolved and it helps to cook food )
Explanation:
hope this helps you pls mark me as brainilst
Answer:
Weigh the empty crucible, and then weigh into it between 2 g and 3 g of hydrated copper(II) sulphate. Record all weighings accurate to the nearest 0.01 g.
Support the crucible securely in the pipe-clay triangle on the tripod over the Bunsen burner.
Heat the crucible and contents, gently at first, over a medium Bunsen flame, so that the water of crystallisation is driven off steadily. The blue colour of the hydrated compound should gradually fade to the greyish-white of anhydrous copper(II) sulfate. Avoid over-heating, which may cause further decomposition, and stop heating immediately if the colour starts to blacken. If over-heated, toxic or corrosive fumes may be evolved. A total heating time of about 10 minutes should be enough.
Allow the crucible and contents to cool. The tongs may be used to move the hot crucible from the hot pipe-clay triangle onto the heat resistant mat where it should cool more rapidly.
Re-weigh the crucible and contents once cold.
Calculation:
Calculate the molar masses of H2O and CuSO4 (Relative atomic masses: H=1, O=16, S=32, Cu=64)
Calculate the mass of water driven off, and the mass of anhydrous copper(II) sulfate formed in your experiment
Calculate the number of moles of anhydrous copper(II) sulfate formed
Calculate the number of moles of water driven off
Calculate how many moles of water would have been driven off if 1 mole of anhydrous copper(II) sulfate had been formed
Write down the formula for hydrated copper(II) sulfate.
#*#*SHOW FULLSCREEN*#*#
Explanation:
For example, water. In its liquid state we drink it , in its solid state (ice ) we use it to make our drinks colder or t numbs pain when wrapped in cloth and it’s gas state ( water vapour) we steam vegetables. In conclusion many different properties of matter are used for various purposes
