<u>Answer:</u> The value of for the given chemical reaction is 0.1415
<u>Explanation:</u>
Equilibrium constant in terms of partial pressure is defined as the ratio of partial pressures of the products and the reactants each raised to the power their stoichiometric ratios. It is expressed as
For a general chemical reaction:
The expression for is written as:
For the given chemical equation:
The expression for for the following equation is:
We are given:
Putting values in above equation, we get:
The value of for the given chemical reaction is 0.1415
Answer:
- <u>Yes, it is 14. g of compound X in 100 ml of solution.</u>
Explanation:
The relevant fact here is:
- the whole amount of solute disolved at 21°C is the same amount of precipitate after washing and drying the remaining liquid solution: the amount of solute before cooling the solution to 21°C is not needed, since it is soluble at 37°C but not soluble at 21°C.
That means that the precipitate that was thrown away, before evaporating the remaining liquid solution under vacuum, does not count; you must only use the amount of solute that was dissolved after cooling the solution to 21°C.
Then, the amount of solute dissolved in the 600 ml solution at 21°C is the weighed precipitate: 0.084 kg = 84 g.
With that, the solubility can be calculated from the followiing proportion:
- 84. g solute / 600 ml solution = y / 100 ml solution
⇒ y = 84. g solute × 100 ml solution / 600 ml solution = 14. g.
The correct number of significant figures is 2, since the mass 0.084 kg contains two significant figures.
<u>The answer is 14. g of solute per 100 ml of solution.</u>
It is make the molecule polar.
Answer:
The structure is shown in the figure.
Explanation:
There is condensation polymersiation in case of lactic acid with the removal of water molecule (dehydration) leading to formation of poly lactic acid.
The structure of PLA is shown in the figure.
Answer:
adding more water to the container
Explanation: because it would cause it to soak up the fluid to created a substance again