The correct answer is A.) Volatile. please mark brainliest (:
Answer:
Explanation:
Scientific notation is the way of writing numbers which are either large or small. The number is written in the scientific notation when the number is between 1 and 10 and then multiplied by the power of 10. Engineering notation is the same version of the scientific notation but the number can be between 1 and 1000 and in this exponent of the ten is divisible by three.
For example, is to be written as in engineering notation.
The given number:
0.00000009345 can be written as
Answer upto 4 significant digits =
Hello!
Atomic Number, is the number where the atom lays on the perodic table and can be found through the number of protons. Meaning that gallium has an atomic number of 31 !
Atomic weight, which is equal to 70 in this case, can be found by subtracting the atomic number from that total to find the remaining number of neutrons that make up the mass. So gallium has 31 protons and 39 protons.
Hope this helps answer your question.
Let us differentiate accuracy from precision. Accuracy is the nearness of the measured value to the true or exact value. On the other hand, precision is the nearness of the measured values between each other. So, for precision, select the student in which the measured values are very near to each other. That would be Student III. Now, for accuracy, let's find the average for each student.
Student I: (<span>8.72g+8.74g+8.70g)/3 = 8.72 g
Student II: (</span><span>8.56g+8.77g+8.83g)/3 = 8.72 g
Student III: (</span><span>8.50g+8.48g+8.51g)/3 = 8.50 g
Student IV: (</span><span>8.41g+8.72g+8.55g)/3 = 8.56 g
From the given results, the accurate one would be Students I and II. So, we make a compromise. Even though Student III is precise, it is not accurate. If you compare between Students I and II, the more precise data would be Student I. Therefore, the answer is Student I.</span>
The steam rotates a turbine that activates a generator, which produces electricity. Many power plants still use fossil fuels to boil water for steam. Geothermal power plants, however, use steam produced from reservoirs of hot water found a couple of miles or more below the Earth's surface.