Answers are supposed to be here, so i will say motor. please put answers here next time
Answer:
a). A conservative force permits a two-way conversion between kinetic and potential energies.
TRUE
Because there is no energy loss in presence of conservative forces so energy conversion in two ways are possible.
b). A potential energy function can be specified for a conservative force.
TRUE
negative gradient of potential energy is equal to conservative force
c). A non-conservative force permits a two-way conversion between kinetic and potential energies.
FALSE
here energy is lost against non-conservative forces
d). The work done by a conservative force depends on the path taken.
FALSE
work done by conservative force is independent of path
e). The work done by a non-conservative force depends on the path taken.
TRUE
work done by non conservative forces depends on path.
f). A potential energy function can be specified for a non-conservative force.
FALSE
It is not defined for non conservative forces
I am assuming you know the relation obtained between slit width, distance of screen from slits, distance of interference pattern obtained on the screen from the center and the wavelength of monochromatic light used in Young's Double Slit experiment.
λ =
λ ~ 1.97 ×10⁻⁷m
= Heat released to cold reservoir
= Heat released to hot reservoir
= maximum amount of work
= temperature of cold reservoir
= temperature of hot reservoir
we know that
eq-1
maximum work is given as
= -
using eq-1
= -
Figure A shows cross section of a land form or rock. In Figure B, compression stress is applied on it. When compression stresses are applied on a rock, it squeezes the rock cause fold or fracture. The fault formed by compression stress is called thrust fault. If the compression stresses/ force continue to act on a rock it will converge and form thrust fault. In Figure C, tension stresses is applied on the rock. When a tension stress applied on a rock it deforms/ lengthen. There are three type of deformations occur due to tension stresses. One is elastic deformation, in which, rock retains it original shape when force/stresses are removed. Second is plastic deformation, in which rock lengthen and change occur permanently. Third type of deformation is result into fracture or breaking of rock. In Figure C, shear stresses are applied on rock. Shear stresses are applied with equal magnitude but in opposite direction. It cause breaking of rock.