What’s the answer choices to pick from?
Wavelength is measured in various units of distance (mm, cm, m, etc.). Frequency uses hertz, but that is not what the question is asking. Therefore, the answer is false.
Answer:
Explanation:
Firstly, when you measure the voltage across the battery, you get the emf,
E = 13.0 V
In order to proceed we have to assume that the voltmeter offers no loading effect, which is a valid assumption since it has a very high resistance.
Secondly, the wires must be uniform. So the resistance per unit length is constant (say z). Now, even though the ammeter has very little resistance it cannot be ignored as it must be of comparable value/magnitude when compared to the wires. This is can seen in the two cases when currents were measured. Following Ohm's law and the resistance of a length of wire being proportional to it's length, we should have gotten half the current when measuring with the 40 m wire with respect to the 20 m wire (). But this is not the case.
Let the resistance of the ammeter be r
Hence, using Ohm's law we get the following 2 equations:
.......(1)
......(2)
Substituting the value of r from (2) in (1), we have,
which simplifying gives us, (which is our required solution)
putting the value of z in either (1) or (2) gives us, r = 0.5325
Answer:
a) Due to the characteristic that a converging lens focuses light rays from infinity and parallel to its main axis. Therefore, the lens should be placed at a distance "f" from the film, in this way it will form the image of the object placed at infinity in said film.
b) Since the converging lens produces an image of an object placed at a distance of 2f, the lens must be placed at the same distance (2f), so that this object that is placed at a distance of 2f is focused.
Explanation: