The answer is 3. Internal energy decrease
Answer:
It can cause an object to accelerate.
It can cause an object to stop moving.
It can cause an object to start moving.
It can cause an object to change directions.
Explanation:
When the velocity of an object is increased in the same direction, the object is said to have positive acceleration. If it increases its velocity in a direction that is opposite to the original direction, it is negative acceleration.
When an object that's already moving is made to stop, it is said to have decelerated. Deceleration is negative acceleration.
When an object at rest is made to move by applying a force, it is said to have accelerated to some final velocity, during its motion for some duration.
An object at rest will remain at rest is said to have no net force acting on it.
Because after each impact it loses a fraction of its original energy, because it gets transfered to the floor. this is the reason that a perpetual motion machine is impossible. you cannot have infinite energy, because to perform a task, energy must be spent. hope i helped :3
Answer:
To investigate into how the height of a ramp affects the speed of a toy car rolled down a hill or slope because the higher the ramp the more Gravitational potential Energy (GPE), the more kinetic energy converted and the car will go faster. So the ramp increases, the velocity will also increase.
Explanation:
Tolerance enables the engineer to be informed when
somethings requires replacement or if there is a drawback with too much war.
The three types of tolerances that appear on dimensioned
drawings are limit, bilateral, and unilateral.
<span>General tolerances are normally found in the
information blocks of the blueprint while a specific tolerance is noted for
certain areas of the blueprint.</span>
