Metamorphic
Metamorphic rocks are formed under the surface of the earth from the metamorphosis (change) that occurs due to intense heat and pressure (squeezing).
Answer
Correct Answer is a.(spikes)
Explanation:
option a is correct because here serves, rotation and spikes all the three words are using as object.
The volleyball team practiced their serves, rotations, and spikes.
option b cannot be correct because here spiking is used as a verb and sentence(The volleyball team practiced their serves, ) is in past indefinite form and we cant use word spiking here because this form of verb is used in continues form of sentences only.
Option c cannot be correct as because in this option ""spikes the ball" spikes is used as a verb which can be used in present indefinite form of sentence only but here sentence is in past indefinite form.
Again option d cannot be correct because in this option ""spikes over the net" spikes is used as a verb which can be used in present indefinite form of sentence only but here sentence is in past indefinite form.
Answer:
Q (reaction) = -69.7 kJ
Explanation:
Octane reacts with oxygen to give carbon dioxide and water.
C₈H₁₈ + 25 O₂ ---> 16 CO₂ +18 H₂O
This reaction is exothermic in nature. Therefore, the energy is released into the atmosphere. This reaction took place in a calorimeter, there the temperature (T) increases by 10 C. The heat capacity of the calorimeter is 6.97 kJ/C
The heat (q) of the reaction is calculated as follows:
Q= -cT, where c is the heat capacity of the calorimeter and T is the increase in temperature
q = -(6.97) x (10) = -69.7kJ
<em>Since the heat capacity is given in kilo -joule per degree Celsius, therefore, the mass of octane is not required </em>
Answer:
False
Explanation:
I would greatly appreciate if you can give the brainliest answer crown!
Answer:
B. Technician B only
Explanation:
An oscilloscope can be used to check the output signal of an optical sensor. The oscilloscope has the functioning of viewing the results in the form of waveform and its time scale settings can be altered to meet the requirements of the results.
A voltmeter cannot be <u>directly</u> used to monitor the output signal of an optical sensor. But a <u>digital multi-meter</u> can be used to check an optical sensor if the digital multi-meter is set on AC - Volt reading mode.