Hear is transferred from the heating elements to the Pot by Conductivity
The tensile stress of the wire supporting 2 kg mass is determined as 6.1 x 10⁷ N/m².
<h3>
Tensile stress of the wire</h3>
The tensile stress of the wire is calculated as follows;
σ = F/A
where;
A = πr² = πD²/4
where;
A = π x (0.64 x 10⁻³)²/4
A = 3.22 x 10⁻⁷ m²
σ = F/A = (mg)/A = (2 x 9.8)/( 3.22 x 10⁻⁷)
σ = 6.1 x 10⁷ N/m²
Learn more about tensile stress here: brainly.com/question/25748369
#SPJ1
Answer:
The final velocity of the vehicle is 10.39 m/s.
Explanation:
Given;
acceleration of the vehicle, a = 2.7 m/s²
distance moved by the vehicle, d = 20 m
The final velocity of the vehicle is calculated using the following kinematic equation;
v² = u² + 2ah
v² = 0 + 2 x 2.7 x 20
v² = 108
v = √108
v = 10.39 m/s
Therefore, the final velocity of the vehicle is 10.39 m/s.
This question is incomplete because the options are missing; here is the complete question:
A runner starts at point A, runs around a 1-mile track, and finishes the run back at point A. Which of the following statements is true?
A. The runner's displacement is 1 mile.
B. The runner's displacement is zero.
C. The distance the runner covered is zero.
D. The runner's speed was zero.
The answer to this question is B. The runner's displacement is zero
Explanation:
Displacement always implies a change of position; this means an object or individual moves from point A to point B, and therefore the original position is different from the final position. Additionally, in displacement, other related factors such as the total distance the body moved and the direction of movement. In the case presented, it can be concluded there was no displacement or the displacement is zero because even when the runner moved and ran two miles, he returned to the initial position, and without a change in the position, there is no displacement.
Answer:
parallel connection:Advandages: 1. Every unit that is connected in a parallel circuit gets equal amount of voltage.2. It becomes easy to connect or disconnect a new element without affecting the working of other elements.3. If any fault happened to the circuit, then also the current is able to pass through the circuit through different paths.Disadvantages: 1. It requires the use of lot of wires.2. We cannot increase or multiply the voltage in a parallel circuit.3. Parallel connection fails at the time when it is required to pass exactly same amount of current through the units.series connection:Advantages: 1. Series circuits do not overheat easily. This makes them very useful in the case of something that might be around a potentially flammable source, like dry plants or cloth.2. Series circuits are easy to learn and to make. Their simple design is easy to understand, and this means that it’s simple to conduct repairs .3. we can add more power devices, they have a higher output in terms of voltage .4. The current that flows in a series circuit has to flow through every component in the circuit. Therefore, all of the components in a series connection carry the same current.Disadvantages: 1.If one point breaks in the series circuit,the total circuit will break.2. As the number of components in a circuit increases ,greater will be the circuit resistance.