Answer: 1.77 s
Explanation: In order to solve this problem we have to use the kinematic equation for the position, so we have:
xf= xo+vo*t+(g*t^2)/2 we can consider the origin on the top so the xo=0 and xf=29 m; then
(g*t^2)/2+vo*t-xf=0 vo is the initail velocity, vo=7.65 m/s
then by solving the quadratric equation in t
t=1.77 s
<h2>Answer:</h2>
All the energy sources are correctly matched with their category.
Explanation:
Renewable energy sources:
These are energy sources which can be replenished as they don't in involves the irreversible phase change.
These resources can never be ended as they can be used again and again.
Wind, geothermal, biomass, bio gas are example of renewable energy sources.
Non renewable energy sources:
These are the energy source which can never be replenished after one time use. They undergo the chemical irreversible change.
These sources are lacking with the passage of time because they can never be reused.
Oil, gas, coal and natural gas are examples.
Answer:
except ii and iii
Explanation:
The angle of reflection is the angle to the normal the white rays strikes the water surface and it is the incidence angle. Since the white light is moving from less dense medium to a denser medium or a medium with a higher refractive index; the angle of refraction will be less than 30 degrees. Total internal reflection cannot occur because the white light is traveling from a less dense medium to a denser medium.
Given :
Reem took a wire of length 10 cm. Her friend Nain took a wire of 5 cm of the same material and thickness both of them connected with wires as shown in the circuit given in figure. The current flowing in both the circuits is the same.
To Find :
Will the heat produced in both the cases be equal.
Solution :
Heat released is given by :
H = i²Rt
Here, R is resistance and is given by :
So,
Now, in the question every thing is constant except for the length of the wire and from above equation heat is directly proportional to the length of the wire.
So, heat produced by Reem's wire is more than Nain one.
Hence, this is the required solution.
Answer:
Now since mass of reactant is equal to mass of the product after the reaction so we can say that mass conservation is applicable here
Explanation:
As we know that zinc reacts with copper sulfate
so the reaction is given as
so here we have
Now total mass of reactant is given as
Mass of the product is given as
Now since mass of reactant is equal to mass of the product after the reaction so we can say that mass conservation is applicable here