Answer:
The correct answer is B) it helps to ensure the result are consistent and repeatable.
Explanation:
Scientist generally repeat an experiment if he or she did not make a mistake in the first one to compare the results of two experiment, if there is no difference in the result or values obtainted from the observation of two experiment. he or she become sure that experiment was done in a right way because if there is some error made when experiment was carried out then the result of two same experiment would be different.
Molality
is one way of expressing concentration of a solute in a solution. It is expressed
as the mole of solute per kilogram of the solvent. To calculate for the
molality of the given solution, we need to convert the mass of solute into
moles and divide it to the mass of the solvent.
<span>
Moles of HCl = 5.5 g HCl ( 1 mol HCl / 36.46 g HCl ) = 0.1509 mol HCl</span>
<span>
Molality = 0.1509 mol HCl / 200 g C2H6O ( 1 kg / 1000 g )
Molality
= 0.7543 mol / kg</span>
<span>The concentration in molality of hcl in a solution that is prepared by dissolving 5.5 g of hcl in 200.0 g of c2h6o is
0.7453 molal.</span>
ADSORPTION: The adhesion of a liquid or gas on the surface of a solid material, forming a thin film on the surface. Not to be confused with the process of absorption.
ABSORPTION: The act or process of absorbing or of being absorbed as
When we increase the surface area of an object, more atoms are exposed. Since more atoms are exposed, the atoms can react faster, and this is why the rate of a reaction increases when the surface area increases.
For example, lets say we want to heat a potato. If we just put the whole potato in the microwave, it will take a long time for the potato to get thoroughly heated. However, if we chop the potato into smaller pieces, we will observe that it gets heated much faster. This is because we increased the surface area of the potato, which resulted in more potato atoms to be exposed to the heat, and caused the reaction to be faster.
